answersLogoWhite

0

pop the hood so you can get to the light and pull the 2 tabs up and release the fixture then pull it twards you twist off and change,repeat the steps backwards and youre done!

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How do you replace the high beam light on a Mitsubishi diamante?

go to your nearest Mitsubishi dealer and request a high beam light replacement.


If just your low beam went out on your headlight is that a fuse or do you need to replace the whole light?

If only the low-beam is out, you will need to replace the low-beam bulb. It is probably not necessary to replace the entire headlight assembly.


How do you replace the low beam headlight on a 2004 Nissan Altima?

The Low Beam AND High Beam are in the same bulb. The procedure to change it will be in the owners manual.


What size is the low beam light for a 2002 Ford Explorer?

According to the 2002 Ford Explorer Owner Guide : The LOW BEAM headlights take bulb ( # 9006 ) Also , the HIGH BEAMS use # 9005


No power to one side of low beam head light?

Filament for low beam is burnt out. Need to replace.


How to replace the high beam light bulb on 2004 Mazda 6?

press 1 at a time 6 and am this should reset it if not give me a call i have done quite a few 07828329160


Right side has lights left side only has low beam?

Replace the left size high beam light.


Turning on fog lights for ford explorer 2004?

I believe you turn your headlights on low beam and then pull out on the headlight switch


What do you mean by DIP BEAM?

dip beam means that one the front light is not working espicially low light so turn on light then see wich one not working and replace it its too cheep and simple


What is Beam of light called?

A beam of light is simply referred to as light or a light beam.


Why is one of your low beam head light dont work?

The light probably burned out. Buy another one and replace it.


What color is the high beam wire on a 2004 Tacoma?

The high beam wire on the 2004 Toyota Tacoma is red with yellow stripes. You can use a test light to determine which wire is active when the high beams are on.