I know your is a 1998 Ford Expedition but it's the same principle... Shift Linkage
Ford Pick-ups and Broncos 1987-1996 Repair Guide Copy & Pastehttp://www.autozone.com/az/cds/en_us/0900823d/80/0a/e8/36/0900823d800ae836/repairInfoPages.htm
The shift cable for a 1998 Ford Expedition allows the transmission to be shifted throughout the available gears. It is linked directly from the shift lever to the side of the transmission.
To replace the shift cable on a 1998 Oldsmobile Silhouette, first, disconnect the negative battery terminal for safety. Then, remove the center console to access the shift cable, detaching it from the shifter and the transmission linkage. Install the new shift cable by reversing the removal steps, ensuring it is properly secured and connected. Finally, reassemble the center console and reconnect the battery.
How do you replace a heater core in a 1998 Ford Expedition?"
How do you replace a heater core in a 1998 ford expedition?"
To replace the auto trans shift cable on a 1998 Oldsmobile Silhouette, first, ensure the vehicle is parked on a level surface and the ignition is off. Remove the center console to access the shift cable connection at the gear shifter and disconnect it. Next, follow the cable to the transmission, detach it from the transmission lever, and remove any retaining clips. Install the new cable by reversing the steps, ensuring all connections are secure before reassembling the console.
If you are no longer able to shift, then it's possible the linkage is broken. If this is a periodic problem, you may need to adjust the linkage or shift cable so that everything is prooerly lined up
how do you replace shift gear light on a 1998 le altima car?
Replace shift linkage Replace shift linkage
You don't as it does not have a cable. You replace the speed sensor instead.
i have a 1998 honda accord the gear shift is locked...
regulater is riveted in
buy new cable remove cables from battery then follow cablr route to opposite end and remove. installation is exact opposite make sure you disconnect negative cable first