unscrew the inside door panel then unbolt old handle install new one . i recommend you spend a few more dollars and get the good handle it is worth it
take it out
W/ a new one
On a 1987 Plymouth Horizon, the ignition module is typically located on the driver's side of the engine compartment, mounted on or near the ignition coil. It may be housed in a plastic or metal bracket. To access it, you might need to remove any protective covers or components that obstruct visibility. Always consult a repair manual for precise location and handling instructions.
Should have access after removing inner door panels
Here are directions for a camary. It is basically the same for the avalon.http://autorepair.about.com/library/weekly/aa092504b.htm
It isn't easy. It bolts on from the inside of the door. TAke the door panel off.
on a 96 chevey Tahoe you take the panel off the inside it allows acess to the bolts holding it on
To replace the exterior driver's side door handle on a 2000 Chevy Prism, start by removing the interior door panel. This typically involves unscrewing screws and gently prying off clips. Once the panel is off, disconnect the door lock and window switch wiring. Remove the retaining bolts for the door handle, detach the linkage, and replace the old handle with the new one, then reassemble everything in the reverse order.
The VIN on a 1993 Plymouth is at the lower left of the windshield and on the driver side door jamb.
The battery on a Plymouth Breeze is on the driver's side of the engine compartment. It is almost all the way back to the firewall between the motor and the driver's side fender wall.
had same problem; check switch on driver side ., if it operates the passenger side ok, then just replace the driver side window switch .. $20 part from the dealer.
On the firewall , driver side.