0
I've never done this on a Chevy Lumina, but I'm pretty sure it's figurable if you've done it in another vehicle. You'll have to remove the steering column assembly (it's a bitch) and you'll find what looks to be fishing wire hooked to a little metal piece if it's not already broken off, shift and look what's moving it and it shouldn't be too hard to figure out.
What else can I help you with?
How do you replace a 2005 Chevy Trailblazer shift cable?
Buy the Cable , then remove the screws that hold the broken cable and attach the new cable back.
How do you replace shift cable for 01 cavalier?
The shift cable on an 01 Chevy Cavalier is replaced by removing the retaining screws, removing the cable from the shifter, and pulling it from the vehicle. A new cable can then be locked into place and bolted down.
Location of primary shift solenoid 96 lumina?
need to know where the shift solenoid is on a 96 Chevy lumina is located so that i can switch out the part. the one that i bought is a shift and lock solenoid, so where is that at on the transmission?
How do you take off a manual transmission shift cable on a 1997 Chevy cavalier to replace it?
It just pops off... Use a screwdriver to pry it off.
1997 Chevy Lumina repair manual?
transmission wont shift from low to high very good
Pontiac sunbird is running but wont shift into drive?
replace the shift cable
Why would a gear shift lever on an automatic 1996 Lumina be very sluggish and hard to move?
bad cable
How to replace the shift indicator cable in a 1994 Cadillac Deville?
The cable is part of the shift indicator assy . Must be replaced as a unit
Where would the shift selonoid be located on a 2000 Chevy Lumina?
Shift solenoids are located inside the automatic transmission, accessable via a side cover plate.
How do you replace automatic gear-shift cable 2000 corolla?
I need to repair the gear shift cable in side a 2000 toyota corolla. How do you get in side the gear shift box to repair the cable end?
How do you remove a shift knob on a Chevy Colorado?
It is glued on you have to replace the entire stick shift
What is the best way to replace an MTB shift cable?
To replace an MTB shift cable, follow these steps: Shift to the smallest gear in the rear and front. Loosen the cable anchor bolt and remove the cable. Thread the new cable through the housing and attach it to the derailleur. Pull the cable taut and secure it with the anchor bolt. Test the shifting to ensure it is working properly.
