0
If you mean the ignition switch- it is located on the steering column under the dash, you can remove the bolts holding the steering column in place and lower it. the switch is on top of the column and easy to get to with it lowered. unplug switch remove nuts, make note of where the actuator rod goes, it must fit into the switch at the proper location, if you haven't moved the lock cylinder you should be fine. after putting rod into little groove in the switch put it back onto column and tighten nuts. reattach plug and secure steering column. it would be good to get a repair manual from NAPA or another store it helps.
What else can I help you with?
How do you replace the ignition module 1990 ford bronco?
To replace the ignition module on a 1990 Ford Bronco, first disconnect the negative battery cable to ensure safety. Locate the ignition module, which is typically mounted on or near the distributor; remove the screws or bolts securing it. Disconnect the wiring harness from the module, then install the new module by reversing the removal process, ensuring all connections are secure. Finally, reconnect the battery and test the ignition system to ensure proper functionality.
How do you replace the turn signal switch located on a 1990 Ford Bronco?
You have to take apart the steering column, remove the steering wheel, remove the ignition switch, and it's a pain in the butt.
Where can you find an early bronco ignition diagram?
1984 ford bronco
Will a tailgate of a 1990 ford bronco fit a 1996 ford bronco?
yup.
How do you put serpentine belt on a 1990 ford bronco with a 5.8 engine?
how do put belt on 1990 ford bronco 5.8
Where is the ignition module located on a 1990 Ford Bronco with a 5.8L engine?
there might two one is under the dash and the other is on the distruber(sp)
Will a ford 460 fit in a 1990 ford bronco 2?
No
How do you replace the fuel pump in a 1993 Ford Bronco?
how do I replace a fuel pump on a 1993 Ford Bronco 302 5.0 L
How to replace 1990 Ford Festiva ignition key lock jammed in off position?
You can't repair it you can only replace it.
Where is the map sensor locatedon a 1990 ford 5.8 efi bronco?
The map sensor on a 1990 Ford 5.8 EFI Bronco is on the passenger side. It is located on the firewall.
In what years was the Ford Bronco 2 sold?
The Bronco 2 was sold between 1984 and 1990. The Ford Bronco 2 was a compact SUV. It was smaller than a full-sized Bronco. It was succeeded by Ford Explorer.
Ford bronco Turns over but doesn't start?
ignition coil
