answersLogoWhite

0

Theres a tab that holds the housing with the bulbs. Sqeeze the outside of the tabs towards the center and pull down. It should just pop out.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

How do you replace a Chevy Tahoe license plate light?

I have a 1997 Tahoe with a trailer hitch. There are two, u-shapped retaining clips on the "inside" of the bumper. Slide the clips off. Now you can pull the housing through the "outside" of the bumper. Twist the socket out of the housing and replace the bulb. Installation is the reverse.


How do you replace a license plate bulb on a Lexus GX470?

There should be 2 screws holding it in from the outside just unscrew them and replace the bulb. If there are no screws most likely the bulb can be accesed from the inside of the trunk lid and easily replaced aswell


How do you replace the license plate bulbs on a 1998 Chevy Blazer?

push up and turn on the housing


How do you replace the license plate light on a 2005 Toyota Sienna?

To replace the license plate light on a 2005 Toyota Sienna, you will first need to locate the light housing on the rear bumper near the license plate. Next, you will need to remove the screws or clips holding the housing in place using a screwdriver or a trim removal tool. Once the housing is removed, you can access the old light bulb, twist it counterclockwise to remove it, and replace it with a new bulb of the same size and wattage. Finally, reattach the housing and secure it back in place with the screws or clips.


How do you replace a 2003 Chevy S10 license plate light?

twist rubber housing a quarter turn pull out replace with new bulb


How to replace the spare tire housing unit on a 2002 ford expedition?

First thing you have to do is remove the spare tire. Then remove the few bolts that are holding the housing in place. Replace in reverse of taking it off.


How do you replace license light bulb on a 2003 Pontiac grand am?

Remove the two 10 millimeter screws and pull the housing down and replace the bulb


How do you replace the thermostat located on a Oldsmobile Ninety-Eight?

Follow the top radiator hose over to the engine and where it connects to the thermostat housing. There should be two bolts holding the housing to the motor. Remove the housing and replace the thermostat and gasket. The larger side of the thermo goes in the engine.


How do you replace the thermostat in a 1996 Toyota Camry?

remove the bolts holding the housing connected to the top radiator hose. go from there


How do you replace the tail turn signal light on a 2000 Honda Odyssey?

Open the tub of the turn signal housing and uncrew the 2 scews holding it and pull out the whole housing .


How do you replace the thermostat located on a 1998 Ford Ranger?

Follow the upper radiator hose to the outlet/sensor housing then to the head. Remove the 2 bolts on holding the housing to access it.


How do you replace the rear lamp housing for the license plate on a 2003 Chevy Tahoe?

Get under the vehicle and look up into the bumper where the housing is located. Squeeze the tabs and push the housing out of the bumper. It takes about 10 seconds.