There should be 2 screws holding it in from the outside just unscrew them and replace the bulb. If there are no screws most likely the bulb can be accesed from the inside of the trunk lid and easily replaced aswell
To install the license plate on a Lexus GX470, first locate the mounting holes on the rear of the vehicle. Align the license plate with these holes and insert the screws provided, ensuring the plate is level. Use a screwdriver to tighten the screws securely, but avoid over-tightening to prevent damage. Finally, check that the plate is firmly attached and visible.
Ask your car dealer...
On the driver's side above the skid plate, near the stabilizer bar.
How do I change the license plate bulb on a 1993 Lexus ES 300
how to replace the license plate bulb on a 2004 Honda cr-v
how do you replace a honda crv licence plate bulb on a 2004
how do you replace license pate light on 2006 pontia g6
To change the license plate bulbs in a Lexus RX 350, start by opening the rear hatch and locating the license plate lamp assembly. Use a flathead screwdriver or a similar tool to gently pry the assembly out of its housing. Once removed, twist the bulb socket counterclockwise to release it, then replace the old bulb with a new one. Finally, reassemble the lamp by inserting the socket back into the assembly, securing it in place, and testing the new bulbs.
The license plate light on a Lexus may turn on and off if there is a loose wire. Try wiggling the wires around and see if the light goes on and off. If it's not a loose wire then the light bulb may have come loose and needs to be tightened.
Unscrew license plate and remove to expose light fixtures. Wedge light module away from holes. Replace them and return them to sockets.
Open the rear hatch and remove the inside trim on the lower portion of the hatch. The bulbs will be accessible once the trim is removed. The bulb sockets are twist in.
It is very easy to change the license plate light on an Oldsmobile Aurora. All you need to do is remove the license plate and look above where the plate was. There are bolts that are holding the light in. Unscrew the bolts and then replace the light.