Open the rear hatch and remove the inside trim on the lower portion of the hatch. The bulbs will be accessible once the trim is removed. The bulb sockets are twist in.
Ask your car dealer...
How do I change the license plate bulb on a 1993 Lexus ES 300
how to replace the license plate bulb on a 2004 Honda cr-v
how do you replace a honda crv licence plate bulb on a 2004
There should be 2 screws holding it in from the outside just unscrew them and replace the bulb. If there are no screws most likely the bulb can be accesed from the inside of the trunk lid and easily replaced aswell
Remove the screws from the lens covering the bulb, pull out the bulb and replace it.
I have a 94 not sure if they are the same but behind the license plate was mine Good luck Answer Improvement (Sept 5. 2010) Remove 4 license plate screws and licence plate Remove 4 hex head screws that hold the license plate/backup light assembly Rotate the license plate/backup light assembly around 180 degrees so you can get to the light bulb holders Carefully turn bulb holders 1/4 and remove bulb holder Carefully remove old bulb and replace with new bulb (#194) Reverse these step to reassemble
You need to unscrew the whole cover panel for license plate.
You need a torx screwdriver....
you buy a new one
Raise the trunk lid...you will see the lights on each side of the license plate...use Phillips screw driver to remove and replace bulb. Just did this takes about 2 minutes.
To replace the license plate bulb on a 2003 Chevy Tracker, first, locate the license plate light assembly at the rear of the vehicle. Use a flathead screwdriver to gently pry off the lens cover. Remove the old bulb by twisting it counterclockwise and then replace it with a new bulb, ensuring it’s secure. Finally, snap the lens cover back into place and test the new bulb to ensure it works.