0
Its tough, but I cut the old factory ball joint in half to get the lower half out of the control arm and the upper half cut and air hammered off the knuckle arm. The replacement did not involve any rivits, just nuts and bolts.
The tools needed are a air hammer gun, air gun, a cut off disc tool(grinding disc), a pry bar, wratchet and various sockets for installation of new ball joint.
!
What else can I help you with?
How do I replace lower ball joints on 1999 Chevy lumina?
Remove the tire and wheel from your 1999 Chevy Lumina. Remove the nut on the top of the ball joint. Pound the ball joint out with a hammer. Reverse the process to install the new ball joint.
How do you drain your radiator for a 99 Chevy Lumina?
i just disconnected the lower hose
Where can you get a picture of where lower raditor hose goes on 1995 Chevy lumina?
You can get that picture from google.com.
Where is the starter in a 1994 Chevy Lumina?
6 cyl.? Look at the lower rear end of the engine.
How do i replace a Lower ball joint in 2001 Kia Rio?
You have to replace the lower control did assembly .
Cost of replacing an intake manifold on 1999 Chevy lumina?
upper or lower? if it's lower you can bet on paying upwards of 400$
How do you replace the front wheel hub on a 1999 Lumina?
The front wheel hub on a 1999 Chevy Lumina is connected to several suspension components. Loosen and remove all the components including the lower and upper ball joints. Pull off the hub assembly and install the replacement.
How do i change both lower ball joints on a Chevy lumina?
take old ones out... put new ones in
Replace cv joint 2004 Chevy aveo?
To replace the CV joint on a 2004 Chevy Aveo, start by safely lifting the vehicle and removing the wheel. Then, detach the axle nut and any necessary components, such as the brake caliper and rotor, to access the CV joint. Remove the old CV joint from the axle shaft, clean the area, and install the new CV joint, ensuring proper alignment. Finally, reassemble all parts, torque the axle nut to specifications, and lower the vehicle.
Where is the starter on a 1999 Chevy lumina?
On a 1999 Chevy Lumina, the starter is located on the lower passenger side of the engine, near the transmission. It is mounted to the engine block and can be accessed from underneath the vehicle. To replace or service it, you may need to remove the battery and some components for better access. Always ensure the vehicle is securely lifted and supported before attempting any work underneath.
Where is the radiator drain petcock on a 2000 Chevy Lumina?
There may not be one, My 2000 Lumina has a plug on the lower drivers side of the radiator that can be replaced with a petcock. Rather than do this I removed the lower radiator hose to facilitate flushing the cooling system.
How do you change a right lower ball joint on 1993 Chevrolet lumina 3.4 car?
To change the right lower ball joint on a 1993 Chevrolet Lumina 3.4, start by safely lifting the vehicle and removing the wheel. Disconnect the tie rod end and the lower control arm from the ball joint, then use a ball joint separator to detach the ball joint from the steering knuckle. Install the new ball joint, reattach the control arm and tie rod, and ensure all components are securely fastened before putting the wheel back on. Finally, lower the vehicle and perform a wheel alignment if necessary.
