I have replaced a non-powered antenna on a 1997 Mercury Villager - I assume they are the same.
1) Jack up the front passenger size of the car.
2) Remove the tire.
3) You can now remove the wheel-well. There are a set or screws around the wheel, and there are blind expansion pins on the inside. To remove the blind expansion pins push the inner pin through then pry the outer hold-down head off.
4) After removing the wheel-well you will see (or feel) the antenna assembly. There is one bolt that you can now reach that holds the unit in at the bottom. At the top the unit is held to the fender with a large ring that can be unscrewed.
I never figured out how to remove the antenna wire that ran to the antenna, so I stripped the wire and spliced in the wire to the new antenna.
Reverse procedure to re-assemble.
how do I replace a power antenna on my jeep Cherokee 1992
how do you replace power antenna on 1988 deville
Begin by removing the wiring harness from your 1994 Mercury Grand Marquis power antenna. Remove the power antenna retaining nuts. The power antenna will come off.
Check fuses If you are getting power to socket, but not through it ,replace socket
To replace the motor on the power passenger front seat of a Mercury Villager, first, disconnect the vehicle battery to ensure safety. Remove the seat from the vehicle by unbolting it from the floor and carefully disconnecting any electrical connectors. Access the motor by removing the seat cover or base, depending on the design. Finally, replace the old motor with the new one, reassemble the seat, and reinstall it in the vehicle.
Motorcraft MERCON ATF
You have to ask a more complete question.
No.
No
Remove the wiring harness from the bottom of your 1987 Chevy Corvette power antenna. Remove the power antenna retaining nuts. Reverse the process to install your new power antenna.
Power seats are usually on a breaker, not a fuse.
Power windows normally use a breaker, not a fuse.