answersLogoWhite

0

You need a special ratchet tool that fits into the two grooves on the caliper cylinder. Twist the caliper clockwise to depress the cylinder. The rotor should fit in between the pads nicely.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How do you remove rear brake rotor on Oldsmobile aurora?

You have to take the two bolts off of the arm then the whole rotor comes off its a size 18mm ned a half inch breaker bar and a pipe is helpful they are stubborn!!


How do you change the rear brakes on a 2002 Oldsmobile Aurora?

To change the rear brakes on a 2002 Oldsmobile Aurora, start by safely lifting the vehicle and removing the rear wheel. Next, unbolt the caliper and slide it off the brake rotor; be sure to support it without straining the brake line. Remove the old brake pads and replace them with new ones, ensuring they are positioned correctly. Reassemble by reattaching the caliper, replacing the wheel, and lowering the vehicle, then pump the brake pedal to seat the new pads.


Where is the battery on a 1999 Oldsmobile Aurora?

Under the rear seat.


Where is the filter gas in aurora Oldsmobile 96?

fuel filter should be fastened to frame under left rear door. remove and replace.


What size door speakers are standard in a Oldsmobile Aurora?

The door speakers in an Oldsmobile Aurora measure 6 inches by 9 inches. These speakers are located in the rear deck.


How do rear brakes on a 1996 Oldsmobile aurora look?

like disk brakes


How do you replace rear rotor and pads on a 1998 Bravada?

You will need to remove the tire and wheel of your 1998 Oldsmobile. Remove the brake pad assembly. Tap on the brake rotor with a hammer or mallet. Slide the brake rotor off. Reverse the process to install the new rotor and pads.


How do you replace rear brakes and rotors on 2000 V6 Oldsmobile?

To replace the rear brakes and rotors on a 2000 V6 Oldsmobile, start by securely lifting the vehicle and removing the rear wheels. Next, remove the caliper bolts and slide the caliper off the rotor, then detach the brake pads. Replace the old rotor by removing the retaining screws (if present) and sliding it off the hub, then install the new rotor. Reassemble by placing the new brake pads into the caliper, reattaching the caliper, and finally, reinstalling the wheels. Always ensure to pump the brake pedal before driving to seat the new pads.


Where is the body control module in a 1997 Oldsmobile aurora?

The body control module, on your 1997 Oldsmobile, is located on the rear suspension. The module is mounted on the passenger side of the rear axle.


Where is the air suspension compressor in an Oldsmobile aurora located?

under the rear passeger side floor outside


How can you remove the rear rotors on a 2002 Oldsmobile Bravada?

To remove the rear rotors on a 2002 Oldsmobile, a wheel puller will be necessary. A wheel puller has a foot that attaches to the hub, with feet that attach to the rotor. The more the wheel puller is turned, the more it pushes on the hub and loosens the rotor.


How do you install battery on 2001 Oldsmobile aurora?

pull front of rear seat up. remove it and battery is right there