0
To replace the thermostat in a Ford Aspire, first, ensure the engine is cool and disconnect the battery. Drain the coolant from the radiator, then remove the upper radiator hose and the thermostat housing bolts. Take out the old thermostat, clean the mating surfaces, and install the new thermostat with a new gasket. Reassemble the housing, reconnect the hose, refill the coolant, and start the engine to check for leaks.
What else can I help you with?
How do you replace a thermostat in a 1997 Ford Aspire and where is it located?
this site^ will show you a how
How do you replace thermostat 97 ford van?
How do I replace thermostat on 97 Ford van
How do you replace thermostat on 1991 ford escort?
Replace thermostat on 91 ford eacort
How do you replace the thermostat on a 2002 Ford Taurus?
thermostat on a ford 2002
Where is the thermostat on a 97 ford aspire?
It is under the distributor. Look for the upper coolant hose (it's about an inch thick) and you will find the thermostat housing.
How do you replace the thermostat located on a 1985 Ford Bronco II what side of the thermostat go?
how to replace a thermostat on a bronco 198511
How do you replace serpentine belts in 1995 Ford Aspire?
There isn't one.
When to replace the timing belts of a Ford Aspire?
every 60,000 miles
How do you replace a thermostat on a 2000 Ford F-250 V10?
To replace a thermostat on a 2000 Ford F-250 V10, drain the radiator. Locate the thermostat on the top hose assembly and remove the screw. Replace the thermostat and refill the radiator.
What would cause your 1997 Ford Aspire heater to blow cold air and never heat up also Temperature gage not to work?
More than likely the thermostat is stuck open. Drain the cooling system, replace the thermostat, and install fresh coolant.
How do you replace a water pump on a 1995 Ford Aspire?
Its behind the timing belt cover
Where is the thermostat on a 1997 Ford Aspire located at?
The thermostat on a 1997 Ford Aspire is located on the engine, specifically at the end of the upper radiator hose where it connects to the engine block. To access it, you'll need to remove the upper radiator hose and the thermostat housing, which is typically held in place by bolts. Make sure to drain some coolant before starting this process to avoid spills.
