0
To reset the computer in a 2008 Pontiac Solstice, you can start by disconnecting the negative battery cable for about 10-15 minutes. This will clear the stored error codes and reset the engine control module. After reconnecting the cable, turn the ignition to the "On" position without starting the engine for a few seconds, then start the car. This process should help reset the computer.
What else can I help you with?
How much gallons does solstice Pontiac hold?
my 2008 solstice holds 13 gal.
How many 2008 Pontiac Solstice cars were made?
Approximately 66,000 Pontiac Solstice cars were produced from 2005 to 2009, with around 15,000 of those being made in the 2008 model year. The Solstice was part of Pontiac's effort to revitalize its brand with sporty, affordable vehicles. Production ended in 2009 when Pontiac was discontinued.
Will a 5l50e fit the Pontiac Solstice GXP?
Yes. Check out the June 2008 edition of high Performance Pontiac magazine. Page 28 shows a Solstice with one of these.
How many 2008 mean yellow pontiac solstice gxp were made?
1,287 manufactured
What is the 0-60 time for a Pontiac Solstice?
5.5 seconds at 56% boost 2008 GPX
How do you reset 2008 Pontiac G6 engine?
i have a 2009 G6 Pontiac that is stuck in the snow it says engine disbaled ...someone told me that there is a reset switch
Can you reset the driver information system on your 2006 Pontiac G6?
how do you reset the tire pressure monitor for the g6 2008
When did Secret of the Solstice happen?
Secret of the Solstice happened in 2008.
Where is the fuel reset switch on a 2008 Chevy Cobalt?
There is no fuel reset switch on any model cobalt if i remember u can do that by disconnecting the battery for a couple of minutes.. that will reset the computer
Can I unhook battery cables and install new battery in a 2008 chrysler town and country without having to reset a computer?
Yes, no reset is required.Yes, no reset is required.
How to Reset change oil indicator 2008 Pontiac G6?
Turn on the key....don't start the car. Push the gas pedal to the floor and release 3 times. Should be reset now.
How do you reset the computer on 2008 dodge ram 1500 hemi?
To reset the computer on a 2008 Dodge Ram 1500 with a Hemi engine, you can disconnect the negative battery cable for about 15 minutes. This will clear the computer's memory and reset the system. After reconnecting the cable, turn the ignition to the "On" position (without starting the engine) for a few seconds to allow the system to recalibrate. Finally, start the engine and let it idle for a few minutes to complete the reset process.
