To reset the ECM (Engine Control Module) on a 1993 Chevrolet Silverado, you can disconnect the negative battery cable and leave it off for about 15-30 minutes. This will clear the stored trouble codes and reset the ECM. After that, reconnect the battery cable, start the engine, and allow it to idle for a few minutes to let the ECM recalibrate. If needed, you can also use an OBD-I scanner to clear codes.
Disconnect the battry for one hour: then reconnect-That should do it.
no ECM's in a 1981
What all does the ECM computer control on my 2006 Chevy k1500 Silverado
To reset the ECM (Engine Control Module) in a 1993 Jeep Grand Cherokee, first disconnect the negative battery terminal and leave it disconnected for about 15 minutes. This will allow the ECM to clear any stored trouble codes. Afterward, reconnect the battery terminal, and the ECM will reset itself. Finally, start the vehicle to ensure everything is functioning properly.
just unscrew the battery terminal by 1 minute, or take off the fuse of the block panel for the same time
do you have link and program a 88 cilverado ecm when replacing
You can reset the ecm with a scan tool or by unhooking the battery.
Yes, but the ECM of the 95 would have to be reflashed to remove the interface with the (electronically controlled) automatic transmission.
To reset the ECM remove the battery cable (s) for a few minutes. Replace cable. ECM has been reset.
Just unhook the battery cables for 5 mins, That will reset the ECM
Does the ecm control charging system on a 93 jeep wrangler and cause it not to charge the battery
check the library at legacycentral.org