Key on engine off, press gas pedal to the floor three times
To reset the oil change light on a Jeep Compass, turn the ignition to the "ON" position without starting the engine. Press the gas pedal three times in quick succession, then turn the ignition off. Start the engine to check if the oil change light has reset successfully. If it remains on, repeat the process.
Key on engine off. Press gas pedal to the floor three times.
With a scan tool after repairing the cause of the code.
Jeep vehicles do not have reset/kill switches.
Turn the key on with the engine off. Press the gas pedal down three times in ten seconds.
How do you reset engine light on jeep liberty diesel
what do you reset the cehck engine light patriot manual transmission 2008? thanks for you support.
With a scan tool.With a scan tool.
Take it to the dealer and get it reset.
To change the license plate light on a Jeep Compass, first, locate the light assembly at the rear of the vehicle. Use a flathead screwdriver or a trim tool to gently pry off the light cover. Remove the old bulb by twisting it counterclockwise and replace it with a new bulb, then snap the cover back into place. Finally, test the light to ensure it’s working properly.
Reset it with a OBD2 scanner.
A 2002 Jeep Wrangler does not have a reset switch.