Key on, engine off, press the gas pedal to the floor three times.
Key on, engine off, press the gas pedal to the floor three times.
How do you reset the 'oil change required' message on 2007 Lincoln Town Car???
How do you reset the message to service engine soon on 2005 Nissan terra
press the reset button
I have a 2008 G5 and reset the oil life message this way. First look in your manual - it will tell you how to reset the message, otherwise do it this way. 1) Turn on your ignition key - do not start engine. 2) Go to engine oil life message. 3) Press and hold reset button, then press menu change button. Release both buttons. 4) A message will be displayed "Reset oil message". 5) Press the reset button. A message "acknowledge" is shown. 6) Press the reset button again. Oil life will be 100%.
Your truck will do this at a set milage just like your oil change message. To reset your oil change message with the key forward (not running) hit your gas 5 times (it may be 6) and a message will appear "oil life reset". To reset you fuel filter life with the key forward (not running) hold your gas and brake for 10 seconds or until the message comes up saying fuel filter life reset. But remember only do this if you accualy did change your filter. The other message your can get is water in fuel. This there is no reset. You have to reach under the fuel filter and crack the drain loose but it's usally better to just change the filter.
how to reset change oil message on 2013 beetle
A 2002 Jeep Wrangler does not have a reset switch.
Read the Manual
to reset the change oil message, hold the Eng-Data and Range buttons at the same time until you see the 100 on the drivers information center.
To reset the change oil message on a 1993 Oldsmobile 98 Regency Elite, turn the ignition to the "On" position without starting the engine. Press the gas pedal three times within five seconds. This should reset the oil change indicator light. If the message persists, you may need to check your vehicle's manual for additional steps.
Press the STATUS control to access the System Check function, the message center will display A/C FILTER XX% RESET FOR NEW. Press and hold the RESET control to set to 100% , the message center will display IF NEW FILTER HOLD RESET. After a successful reset, the message center will display A/C FILTER LIFE SET TO 100%.
Jeep does not have reset switches.Jeep does not have reset switches.