answersLogoWhite

0

i heard that you disconnect the battery terminals from the battery and then touch the two DISCONNECTED teminals together for about a half hour.

User Avatar

Wiki User

18y ago

What else can I help you with?

Related Questions

How do you get a 1995 Dodge Intrepid out of limp home mode?

fix the problom that put it in limp home mode then reset the computer


What is the turbo limp module 06 Volvo s60?

Limp home mode is just as it sounds. It goes to a preset load of values to allow the car to get you "limp" home or to the repair service. All engine and transmission performace is reduced. There is no such thing as a "turbo limp module".


How do you reset Renault espace from limp home mode?

To reset a Renault Espace from limp home mode, start by turning off the engine and waiting for a few minutes. Then, turn the ignition back on without starting the engine, allowing the vehicle's systems to reset. If the issue persists, check for any fault codes using an OBD-II scanner and address any underlying problems. Finally, restarting the engine may clear the limp home mode if the issue has been resolved.


Can a bad cam sensor cause the transmission not to shift properly?

It could possibly, if it causes the computer to go into a limp home mode.


How do you fix a P0705 code in my Infiniti G20?

Automatic Transmission Valve Body IS BAD AND NEEDED REPLACEDA MANUFACTURER Valve Body WILL HAVE A STEAL SLEEVE AND ALL NEW PART FOR THE VALVE AFTER BEING BORE OUT.FLUID IS LEAKING BY THE PISTON TRANSMISSION / IF TRANSMISSION SHOP DOES NOT INSTALL A NEW VALVE BODY SAME TIME LIMP MODE WILL COME SOON.NOT CHEAP OR NEW FACTORY TRANSMISSION / I AS GETTING LIMP HOME MODE 2-5 TIME A WEEK. FOR 8 MONTHS I REPLACE WITH NEW VALVE BODY NO MORE P0705 (LIMP HOME MODE)


What causes a 1991 dodge grand caravan to be stuck in limp home mode?

Any transmission related failure. You need to have the transmission computer checked for codes to know possible causes.


What is limp mood grand vitara?

Don't know about Vitaras. But Limp Mode for a Rangerover is where the overcomplicated electrical checks find a fault and to stop additional damage your car is limited to Limp Mode and can only crawl home. You need to get to a garage or find some otherway of resetting the system to start again properly. More often than not in Rangeys it's the sensors that have gone wrong and the actual car would've worked fine. So whatever error message thats causing Limp mode would need to be resolved/reset.


Why does the OD light in a 1996 mercury mystique flash?

because you have a problem with your transmission and it is now in limp mode.it is probley shifting hard into each gear to.. need to flush trans and reset computer


How do you reset limp home mode on a 2006 Chevy Trailblazer?

1st repair the problem 2nd Use the scanner to clear the codes set in the computer system


What is the limp in gear for 4t65e?

The limp mode in a 4T65E transmission typically occurs when the transmission control module (TCM) detects a fault, such as a sensor malfunction or internal failure. In this mode, the transmission limits its functionality to prevent further damage, usually restricting it to second gear or "limp home" mode. This allows the vehicle to be driven but at reduced performance, prompting the driver to seek repairs. It's crucial to diagnose and address the underlying issue to restore normal operation.


What is limp mode in cars?

enables limp home without damaging the engine.


On a 1995 rodeo can the transmission mode switch cause the transmission go into limp mode?

yes it can my 91 rodeo 3.1 v6 has that problem as we speak,tranny light flashing and in limp mode