Insert a pin or other small pointed object into the hole marked "date/time set" (just left of 'date/time set' label) on Driver Information Center panel.
It takes six pushes of the inserted pin to set.
1. First push, and the minutes will flash.
2. Second push, the hours will flash.(In this mode, you can change the AM or PM by pushing either the 'Range' or "Temp Time" buttons, scrolling the hours until either the AM or PM is displayed.)
3. Third push, the date will flash.
4. Fourth push, the month;
5. Fifth push, the year;
6. When you push it a sixth time, you will exit from the time set mode.
hope this may help, on my 88 eldorado. it is reset or changed by pin hole. Look for a small needle hole in the area of display. mine is on lower right corner of center console, right below time and date display message.
The idle speed on your 1995 Cadillac Eldorado can be set by adjusting the fuel pump adjustment screw. Turn the screw to the right to increase the idle speed.
To set the time and date in a 1988 Cadillac Eldorado, first turn the ignition key to the "On" position without starting the engine. Locate the digital clock display on the dashboard; press and hold the "HR" button to set the hour and the "MIN" button for the minutes. For the date, use the "DATE" button to cycle through the month, day, and year, adjusting each with the corresponding buttons. Once set, simply release the buttons to save your changes.
.035" is factory using standard point type ignition.
the secret is to have the radio off set button then just play with scan and seek
To set the clock on a 1989 Cadillac Brougham, first turn the ignition to the "On" position. Locate the clock setting button, usually found on the dashboard or near the radio. Press and hold the "H" button to set the hour, and use the "M" button to adjust the minutes. Release the buttons once the desired time is displayed.
To set the clock in a 1991 Dodge Stealth ES, first, turn on the car's ignition. Press and hold the "Clock" button until the display starts flashing. Use the "Hour" and "Minute" buttons to set the correct time, then press the "Clock" button again to save your settings. The clock should now display the updated time.
Turn on the power knob for the radio/clock. Wait until the clock display shows up. Press "set", and use the "scan" and "seek" buttons to set the time. Hope this helps!
Push the set button then use the seek and scan buttons on the radio
1991-1993 DeVille reset clock in radio on models W/Cassette: 1. Ignition on. 2. Radio on. 3. Press and release "set" button. 4. Within 5 seconds push "scan" button until the clock is at the correct hour. 5. Press and release "set" button. 6. Within 5 seconds push "seek" button until the clock is at the correct minute. Done
With the ignition on, press and release the "set" button on the radio. Within 5 seconds, push the "Scan" button to set the hour, push seek to set the minutes.
likely thermostat is stuck. The temp blend door actuator has failed.