0
upper or lower? either way, remove all wiring, 8 10mm bolts that hold upper intake, both fuel lines in right rear(inlet, outlet) remove upper intake. 8 13mm bolts hold lower intake. dont need to remove lower intake if u r replacing injector assemble which is probably what u r doing as this is a very common problem with the vortex engine. be sure to replace as assembly and not just regulator if the vehicle has 100k plus
What else can I help you with?
Where is the starter motor on BMW Z3?
The starter is located under the intake manifold, and you will have to remove the intake manifold to get to it. Do not forget to buy a intake gasket before you take it off, because they always fall apart when you take the intake manifold off.
Where is MAP sensor in 1997 Blazer?
Oh, the MAP sensor in your 1997 Blazer is usually located on the intake manifold or firewall. It's a small, important part that helps your engine run smoothly by measuring the air pressure in the intake system. Just take your time and follow the hoses from the intake manifold to locate it, and remember, there are no mistakes, just happy little accidents in the world of car maintenance.
How do you replace the thermostat in a 1992 Buick century?
my dad and me took off the manifold and air intake off to get to it. and it didn't take more than a hour
How to take intake manifold off a 1994 Ford Falcon ed?
how to replace intake manifold for 1994 ford falcon ED
How do you fix a hole in a aluminum intake manifold?
Remove the intake manifold and take it to a welding shop that works with aluminum. Let them determine if it can be saved or not.
Where is the manifold in a 1995 Cadillac ElDorado?
The intake manifold is underneath the plastic silver cover held down by four nuts. Take it off and you'll find the intake manifold - also plastic. Even more unusual, the starter is underneath the intake manifold!
Were and how do you take out the starter on 4.6 northstar?
under the intake manifold
How many hours to replace lifters in Chevy 350?
It depends on what you have to remove to get the intake manifold off. Once the intake manifold is off it will take about an hour.
Why will a 1992 Dodge Dakota stall when cold?
It is your Idle Airflow Censor. It is located behind your air intake manifold by two screws. Take it out and clean it off and it will fix your problem.
Where is the starter motor located on a 1998 Cadillac eldorado?
it is under the intake manifold. you need to take the fuel rail off and take the intake manifold off to get to it it sits in the valley between the cylinder banks
How do you remove the intake manifold on a 2004 Mitsubishi endeavor?
To remove the intake manifold on a 2004 Mitsubishi endeavor, you should take it to a mechanic. An authorized dealer will also fix it for you.
Where is the head gasket located on a 1992 Pontiac grand am?
Between the head and the block. First, remove intake manifold and exhaust manifold. Take the valve cover off and unbolt the head. Then, pull the head off and you'll see the gasket.
