0
What else can I help you with?
What would cause a hole in the intake manifold?
If the intake is aluminum your antifreeze ate a hole in it.The same thing happened to me on my wifes van ,I was able to fix the hole with JBweld and 3 years later still no problems ... Good luck. Essentially, poor design. Gm's 3.1 and 3.8 motors are notorius for them failing. Even the Lincoln 4.6 falls into the same category.
How do you fix intake gasket on 2000 lasabre?
The only fix for a bad intake gasket is to remove the intake manifold and replace the gasket.
How much would it cost to fix the manifold on a 2003 Ford Windstar?
Need to know if it is the intake manifold or an exhaust manifold and what is wrong with it.
If there is a hole in the top half of my intake manifold can i repair it or must it be replaced?
I had a hole small hole in one of the manifold covers on my truck, noticed it after I saw lots of steam coming out of it, so I used heat tape( got from Checker Auto Parts) to cover it, and to date it's still holding. (mind you this is only a temporary fix)
How do you fix a oil leak from intake manifold gasket?
By replacing the whole gasket.
How do you remove the intake manifold on a 2004 Mitsubishi endeavor?
To remove the intake manifold on a 2004 Mitsubishi endeavor, you should take it to a mechanic. An authorized dealer will also fix it for you.
How do you fix a intake manafold control fault for 98 escort?
The spi Split Port Induction intake manifold will have to be replaced.
How to fix the heater hose that is inserted into the intake manifold on a 1995 305 v8?
The connector into the intake manifold of a GM 305 and 350 has been known to be quite fragile. If the connector has broken you have little choice but to replace the manifold.
Where is knock sensor located in a 1998 Subaru Outback?
on top of the engine block under the intake manifold. it can be accessed without removing the manifold. easy fix!
How long will a Buick Century last?
if taken care of 250-300k, fix the manifold intake. good cars
What can you do to fix a PO174 code?
depending on what engine maker it is , likely an intake manifold or vacuum leak, ck that first
How do you fix a hole in a dryer vent?
Duct tape or aluminum tape either can with stand the heat
