I am not sure this is the trouble, if you remove the cover on the steering wheel there will be a large nut if this nut is tight the splines on the wheel could be bad, might be looking at replacing the column, or the steering wheel. I the nut is loose simple tighten and replace cover.
The ignition switch on a 1984 Dodge pickup truck is typically located on the steering column. To access it, you may need to remove the lower steering column cover. The switch is usually mounted near the ignition lock cylinder, where the key is inserted. Always refer to a service manual for specific details related to your model.
To remove the ignition switch on a 1981 Dodge pickup, first disconnect the battery to ensure safety. Then, remove the steering column cover to access the ignition switch. Disconnect the wiring harness from the switch, unscrew the mounting screws, and carefully pull the switch out. Finally, replace with a new switch and reassemble the steering column cover and battery connections.
im in the same boat as you but i have an idea where the tccm is. it is located underneath your dash near the steering column
Under the steering column under the dash.Under the steering column under the dash.
A schematic for a 1969 Dodge steering column can be found in an automotive repair manual. Chilton is a popular manufacturer of this type of manual.
How do I get a diagram of how to rebuild the steering column on a 1990 dodge ram 4x4, tilt wheel
Right hand side of the steering column.Right hand side of the steering column.
look in the instruction booklet
Assuming that it is anautomatic And it's just the shifter that you want, at the bottom of the shifter by the steering column there is a pin. Take a punch and drive the pin out.
its under the steering column
It is under the steering column.
The squeaking of a steering column can usually be fixed by adding power steering fluid. It can also be fixed by replacing the belt in the car.