Have you tried to allow the belt to fully retract? The belt is designed to 'engage' the locking mechanism when fully extended -- you'll hear a 'click' when it reaches the end of it's reach. This is all so you can use the belt to secure in a child seat without using any extra clips and such. Pull the belt all the way out, hear the click, route it 'round and through the proper channels of the seat, pull it tight, and the mechanism will keep the belt tight and from losening, holding the seat secure. To release the lock, allow the belt to fully retract.
Fasten your seat belt or live with it, it will stop after a few moments.
By wearing your seat belt.
Pull the vinyl cover off of the seat belt, then roll the seat belt back on the roller.
Well, have to click the botton to unlock it
press the boytodpgh on theleft
If you seat belt is faulty you should have it replaced. If it fails on you in an accident you may be killed.
To replace the passenger seat belt in a 2006 Pontiac Vibe, first, remove the lower trim panel near the seat belt anchor using a trim tool or screwdriver. Next, unbolt the seat belt assembly from the floor and the upper anchor located on the side pillar. Install the new seat belt by reversing the removal process, ensuring all bolts are tightened securely. Finally, test the seat belt for proper operation before reattaching any trim panels.
My back passenger seat belt locked up, and wouldn't unlock. I folded the seat down, peeled back the cover to seat belt locking mechanism, and tried everything but could not get it to unlock. Finally, I gave it a small whack with my hand, and it unlocked and is now working fine.
Push the red button on the seat belt buckle.
The easiest way is to use the seat belt. There is also a method to described in http://forums.genvibe.com/zerothread?id=18678 for 2005-2007 models
your joking right ?
serpentine belt routing vibe 2007