The engine and transmission must be a normal operating temperature before attempting to read the fluid level on the dipstick. Drive the car a few miles, then while stopped with the brakes applies, put it in each gear slowly and return to Park in the same manner. Leave the engine running, then check the dipstick level. If it is low, add a little bit at a time and recheck the level. You will do great harm to the transmission by overfilling it, so that is why to add a little amount at a time to make sure it does not get over filled.
Should be a plug at the side of the transmission- fill to this level
On a 1997 Mercury Tracer : The AUTOMATIC transmission fluid dipstick would be on the side of the transmission ( transaxle ) in the area of the brake fluid reservoir . The manual transmission ( transaxle ) does not have a dipstick
4.1 Qt.s
No check , Just drain and add 2.83 qt. ATF in the speedo hole !
To add transmission fluid to a 1999 Mercury Tracer, locate the transmission dipstick tube, which is typically found near the back of the engine bay. Remove the dipstick, use a funnel to pour in the recommended type of transmission fluid, and check the fluid level using the dipstick to ensure it’s at the correct level. Be sure to add fluid gradually and check frequently to avoid overfilling.
According to the 1997 Mercury Tracer Owner Guide : For the automatic and manual transaxle ( transmission ) ( Motorcraft MERCON Multi Purpose automatic transmission fluid )
Dexron/mercon
PULL THE DIPSTICK ! * The dipstick is located between the engine and battery on the driver's side.
On the 93 escort, brother to Tracer, there was only a breather valve at the top of the transmission and fluid needed to be added by removing an access bolt OR it had a small yellow dipstick at the top of the transmission.
Down the tube that holds trans dipstick.
I believe it's dextron/mercron II
The 1995 Mercury Tracer with a 1.9L engine typically requires about 6 to 7 quarts of automatic transmission fluid when performing a complete fluid change, including the torque converter. Always check the owner's manual for specific recommendations and ensure you use the correct type of fluid, which is usually Mercon or Mercon V for this vehicle. When checking fluid levels, it's best to do so when the transmission is warm and running.