0
The cable connects to a bracket at the side of the carburetor with the accelerator linkage.
When the throttle pedal is fully depressed, the trans cable is also pulled to it's limit, which holds the trans in passing gear.
The bracket can be purchased from many aftermarket parts suppliers.
What else can I help you with?
Do you have to have the TV cable took up on 350 trans?
What??? There is no TV cable on a transmission.
How many bolts connect a 350 turbo transmission to a 350 engine?
6
What does the speedometer cable need to work properly in a 1978 Oldsmobile cutlass supreme 350 hydramatic transmission Fluid is leaking where the cable goes into the transmission?
For the speedometer cable to work properly in a 1978 Oldsmobile Cutlass Supreme with a 350 Hydramatic transmission, it requires a secure connection to the transmission and must be adequately lubricated. If fluid is leaking where the cable enters the transmission, it may indicate a worn or damaged seal, which could lead to inaccurate speed readings and potential damage to the cable. Addressing the leak by replacing the seal and ensuring the cable is properly installed can restore functionality. Regular maintenance of the cable and surrounding components is also essential to prevent future issues.
What does the speedometer cable need to work properly in a 1978 Oldsmobile cutlass supreme 350 hydramatic transfer. Fluid is leaking where the cable goes into the transmission?
For the speedometer cable to work properly in a 1978 Oldsmobile Cutlass Supreme with a 350 Hydramatic transmission, it requires a secure connection to the transmission and should be free of kinks or damage. The leaking fluid at the cable's entry point into the transmission suggests that the sealing mechanism, such as an O-ring or gasket, may be worn or damaged. Replacing the worn seals and ensuring the cable is properly seated can resolve the leak and restore functionality to the speedometer. Regular maintenance of the cable and its connections is essential for optimal performance.
How many bolts connect a 700r4 transmission to a 350 engine?
6
How can you put a 700r4 transmission in a 1975 350 Chevy engine?
To install a 700R4 transmission in a 1975 350 Chevy engine, you'll need an adapter plate to connect the transmission to the engine's bell housing. You'll also need to modify or replace the driveshaft and ensure the transmission mount aligns properly. Additionally, consider upgrading the cooler lines and ensuring the correct linkage for the throttle and kickdown cable, as the 700R4 requires a different setup compared to the stock transmission. Lastly, make sure to connect the necessary wiring for the overdrive function and any electronic components.
Where does speedometer cable mount on turbo 350 transmission?
The speedometer cable mounts on the Turbo 350 transmission at the tailshaft housing. Specifically, it connects to a speedometer gear located in the housing, which is driven by the output shaft. To install or remove the cable, you typically need to unscrew the retaining nut or clip that holds it in place. Always ensure the cable is properly seated to avoid speedometer inaccuracies.
Is there a speedometer cable on a 2001 350 super duty auto transmission?
No. No more speedo cables, they are replaced by electronics.
Where is the speedometer gear located inside a 73 350 transmission?
The drive gear is in the tail shaft of the transmission. The driven gear is on the end of the speedometer cable housing.
What transmission will fit a 1977 camaro 350 engine?
I have a 350 turbo in mine Just about any transmission will work! Powerglide, Turbo 350 (lockup or non) or Turbo 400, even 700r4.
Can a TH-350 transmission operate without a kick down cable?
yes with out the cable connected properly and you are going up a hill it will not go into passing gear. or downshift when needed.
Will a turbo 350 transmission work for a Chevy 4.3 V6?
yep, of course
