0
What else can I help you with?
How do you switch out ignition switch on a 1985 c10 Chevy pickup 4x4?
Remove the retaining ring at the top of your 1985 Chevy ignition switch. Slide the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.
How do you replace the ignition lock on 1985 pickup?
To replace the ignition lock on a 1985 pickup, first disconnect the negative battery terminal to prevent any electrical issues. Remove the steering column cover by unscrewing it, then locate the ignition switch and remove any retaining screws. Disconnect the wiring harness from the ignition lock cylinder, insert the new lock cylinder, and reassemble the steering column. Finally, reconnect the battery and test the new ignition lock to ensure it functions properly.
What is the firing order for a 1985 Toyota SR5 pickup?
The firing order for a 1985 Toyota SR5 Pickup is 1-3-4-2.Additional info FYI: Ignition timing: TDC #1 cylinder location: FRONT Distributor rotation: CLOCKWISE Spark plug gap: .032"
What is the gear ratio for a 1985 Chevrolet k10 pickup?
What is the gear ratio for a 1985 CHEVROLET K10 pickup
How would one change the drivers side window motor on a 1985 GMC 1500 pickup?
i need a diagram to install a window motor on a 1980 gmc truck
How do you wire a starter in a 1985 Chevy 305 pickup?
To wire a starter in a 1985 Chevy 305 pickup, first disconnect the battery to ensure safety. Connect the positive battery cable to the starter solenoid terminal marked "B" or "BAT." Attach the smaller wire, usually a purple wire, to the solenoid terminal marked "S," which activates the starter when the ignition key is turned. Finally, reconnect the battery and test the starter by turning the ignition key.
What is the payload for a 1985 Chevy S10 Pickup?
The payload for the 1985 Chevy S10 pickup is between 1000 and 1500 pounds depending on the exact model. The S10 is the smallest of the Chevrolet pickup series.
How to drill out ignition switch on 1985 Ford F-150?
How to drill out ignition switch on 1985 ford f150?
How can you remove the gas sending unit from your 1985 Dodge pickup?
Disconnect and lower fuel tank from vehicle. Release lock ring from sender and pick up assembly. Install new.
If a 1985 Toyota pickup does not have power steering can power steering be installed if so what parts are needed?
Yes you can install power steering. I have installed it in my 84 pickup. You will need the power steering box and the gear box with hoses. I pulled them off a pickup at a wrecking yard, which is best, since everything is already there and you can see how it is setup.
What would cut current to the fuel pump other than a fuse or a broken wire in a 1985 Nissan pickup?
check for a fuel pump relay and make sure there is current coming from the ignition switch.
How do you replace the spark plugs in a Nissan pickup 1985?
You must remove the old ones and install new ones. If you have never done it, get a mechanic to do it. If you break a spark plug off in the head, you will never get it out.
