0
Replacing the idler arm on a 2000 Pontiac Montana can be moderately challenging, depending on your mechanical skill level. It typically involves lifting the vehicle, removing the wheel, and disconnecting various components to access the idler arm. If you have basic tools and some experience with vehicle maintenance, it can be done in a few hours. However, if you're unsure, consulting a professional mechanic is advisable.
What else can I help you with?
Can you bypass ac on 2000 Cherokee sport?
yes there is a idler pully and bracket that gose in place of the compressor a little hard to find
How hard is it to replace head gasket on a 2000 amigo?
Having a head gasket replaced on a 2000 Amigo can be replaced but it can be hard depending on if the mechanic has the right instructions. Also, depending on the condition of the head gasket can depend on how hard it is replace the gasket.
How hard is it to replace fuel pump on 2000chevrolet truck?
how is it to replace fuel pump on 2000 Chevrolet truck
What is the pulley under the alternator in a 1994 Chevy caprice 5.7L and how hard is it to change?
Are you talking about the "idler pulley"? They are quite simple to change. Loosen the serpentine belt by using a socket on the center of the tensioner pulley, slide the belt off the idler pulley, use a socket to pull the center bolt of the idler pulley and replace the pulley with a new one.
How hard to replace a pcm and ecu on a 2000 Mitsubishi Galant?
need diagram of how to install pcm in a 2000 mitsbishi galant
Hard shifting with 2000 Pontiac Montana a computer problem?
Could be computer related. But alot of time the shifter Solonide goes on them. Get it checked out for that.
Cost to replace a flywheel of a Volvo S80 2000?
how hard is it to remove a flywheel on 2002 volvo s80
What causes rough idleing for a 2000 ford explore?
check the idle control valve not that hard to replace and inexpensive
Is it hard to get on Hannah Montana?
yes
1997 Cadillac STS is squealing should you replace the belt or the idler pulley and how?
check to see if the belt is cracked or hard. hard or cracked belts are prone to sqealing. also you can use a stethescope or screwdriver(the cheap way) to listen to the pulley itself. carefull not to get caught in the belt while doing this.
Has karlie Montana does hard core?
Yes she did
Why is the front end on my 2000 ford f-150 4x4 squeaking?
Replace upper and lower ball joints. Not hard, but time consuming.
