answersLogoWhite

0

500 degrees

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

How hot does an engine block get?

5 degress


Will water crack a engine block?

Yes. You can freeze the water, making it expand, or you can add cold water to a hot engine, shocking the block. You prevent freezing with antifreeze. You prevent shock by never adding water to a hot engine. If there is enough water in the engine to have the water pump provide circulation, you can add water SLOWLY, but you should really only add water to a hot engine when there is very little to add.


Why is your peugeot epert 2.0 hdi a problem to start when the engine is warm?

There is a large screw which goes through the coil pack into the engine block. That screw will get to hot and then cause the engine to stop or not start back when it's hot.


What wire is the hot wire and ground wire in a 1990 cutlass supreme?

the hot wire goes to the starter and the ground wire bolts to the engine block.


What is the part on the engine block that sends the information to the hot and cold temp gage called?

In the engine block of a vehicle, the part which is responsible for sending information to the temperature gauge is called the temperature gauge sending unit.


Water is used to cool the radient of hot car engine?

Yes, water cools your engine. A water pump draws water from the radiator and into pores in the engine block, cooling it off. There is a thermostat that lets the hot water out of he engine at a certain temperature so the hot water cools off in the radiator with wind and the cold water goes in the engine.


What is the firing pattern for a cougar 454 BB engine?

sorry, the 454 Big Block engine was used in General Motors vehicles. Apparently you have a HOT ROD!!


Which of these is a true statement about incediary grenades?

They burn at over 3500 degrees Fahrenheir and hot enough to melt an engine block


Which is these is a true statement about incendiary grenades?

They burn at over 3500 degrees Fahrenheit and hot enough to melt an engine block


When was The Block Is Hot created?

The Block Is Hot was created on 2006-03-12.


What causes a loose engine block and can it be repaired?

it is not a cracked engine block it is just a loose block


Where is the block drain plug for coolant on G M 4.8 engine?

On the GM 4.8 engine, the block drain plug for coolant is typically located on the driver's side of the engine block, towards the rear. It is a small threaded plug that can be removed to drain coolant from the engine block. Make sure to allow the engine to cool down before attempting to remove the plug to avoid burns from hot coolant. Always check the vehicle's service manual for the exact location and specifications.