0
What else can I help you with?
How long does it take to replace ball joints in Chevy Malibu?
Typically, an experienced technician will take 2 to 3 hours to replace the ball joints. Alignment will take an hour and transmission flush will take less than an hour.
How long does it take to change the ball joints?
it depends if you have a ball joint presser. i would say about an hour
How long do lower ball joints typically last in 2006 mustang?
30,000 miles. I have a 2006 Ford mustang with 30,800 miles and i need my lower ball joints and control arms replaced
How long does it take to install upper and lower ball joints on a 1988 Jaguar XJ6?
Half an hour
What are 2 kinds of joints what are the 3 movable joints?
# Hinge joints allow movement in one direction, as seen in the knees and elbows. # Pivot joints allow a rotating or twisting motion, like that of the head moving from side to side. # Ball-and-socket joints allow the greatest freedom of movement. The hips and shoulders have this type of joint, in which the round end of a long bone fits into the hollow of another bone.
How long should the lower ball joints last on a 98 Chevy blazer can't get more than a year out of a set?
YOU CAN GET A FEW YEARS OUT OF A SET OF BALL JOINTS, BUT THEY WILL NEED TO BE GREASED REGULARLY. USUALLY YOU WOULD HAVE THEM GREASED AT THE SAME TIME AS YOU HAVE YOU CAR SERVICED(OIL CHANGE ECT). A NEW SET OF BALL JOINTS MUST BE INSTALLED CORRECTLY USING THE PROPER TOOLS OR BY A PROFESSIONAL. SOME MANUFACTURERS OF AFTER MARKET PARTS HAVE POOR QUALITY PARTS AND THEY DO NOT LAST AS LONG AS THE ORIGINAL MANUFACTURERS PARTS DO. MY FATHRE HAD A SIMILAR PROBLEM WITH HIS CHEV SUBURBAN. WE HAD TO REPLACE THE BOTTOM BALL JOINTS A SECOND TIME WHEN WE HAD ONLY A REPLACED THEM A YEAR BEFORE. LUCKLIY FOR US THE MANUFACTURER OF THE AFTER MARKET PARTS HAD A WARRNTY ON THE BALLJOINTS AND WE HAD THE PARTS REPLACED WITH A NEW SET FREE. YOU MAY WANT TO CHECK WITH THE PART SUPPLIER YOU PURCHASED YOUR PARTS FROM TO SEE IF ANY WARRANTIES APPLY.
How do you replace CV joints on a 1993 Mercury Topaz?
They are labor intensive if you just replace the joints. What I do is replace the shaft which in the long run is cheaper. Two options: buy a good used one at a salvage yard ( approximate $75.00) or a rebuilt unit ($125.00 exchanged. )Check prices and warranties. Good luck.
Why do bones join together?
The places in your body where two or more bones are joined together are called joints. Some joints are fixed, they do not move, and some joints are movable. Fixed joints are found where one bone lies against another, sometimes with a thin layer of tissue separating them. Joints like these do not move at all, but the tissue is able to soften a hard blow you might receive and keep your bones from breaking. The joints of the bones in your skull are examples of fixed joints. Movable joints are divided into three types, depending on their uses. There are hinge joints, pivot joints, and ball and socket joints. Hinge joints allow the bones to move forward and backward, much like a door opens on its hinges. Hinge joints are found in your knee and fingers. Pivot joints permit the bones to rotate, or turn around. When you move your head from side to side, or rotate your arm at the elbow, you are using pivot joints. But the joints which give you the most movements are ball and socket joints. This is because of the way they are shaped. A long bone joins a shorter bone in this type of joint. The long bone has a large round end that fits into a hollowed-out curved section of the shorter bone, much like the way a ball would fit into the curled-up palm of your hand. Ball and socket joints give you the freedom of movement in your shoulders and hips. Of the 22 bones connected by joints in your skull, only one can move, the one in your lower jaw, which permits you to talk, laugh, and chew food!
Can you spray wd-40 on the ball joints to stop it from squeeking?
That is a bad idea. WD40 is not a high pressure lubricant and will clean out the good lube (Grease) It HAS to be replaced, you dont want that to fail on the freeway. Your wheel will come off and it may send you into oncoming traffic.
Can you replace your golf ball anywhere on your marker on the green has long its not nearer the hole?
everywhere ive been, yes
What s the towing capacity of a 2005 ford f350?
I have a 5.4 v8 F350 XLT (regular cab long bed) and it has 3:73 gears and I believe the towing capacity is 16,000 pounds.
The joints between the phalanges are classified as?
The joints between the phalanges are classified as hinge joints. These joints allow movement in one plane, primarily flexion and extension.
