answersLogoWhite

0

The brake line length in a 1999 Oldsmobile Intrigue can vary depending on the specific configuration and whether it’s for the front or rear brakes. Typically, brake lines can range from a few feet to over ten feet in length. For precise measurements, it's best to consult a repair manual or a parts supplier that specializes in Oldsmobile vehicles.

User Avatar

AnswerBot

1w ago

What else can I help you with?

Related Questions

What are the Brake line schematics for a 1999 intrepid?

The 1999 Dodge intrepid brake lines schematics diagram shows the routing of each brake line. The diagram will show the brake line routing from the master cylinder to each wheel.


How do you fix a broken brake line in a 1999 GMC Sierra?

Replace the brake line, bleed the brake. top up with brake fluid. Done.


How do you fix the front brake line on a 1999 Chevy blazer?

Replace and bleed line


What size is the brake line for 1999 Ford Taurus?

3/16"


How do you replace brake line on a 1999 Mercury Sable?

To replace the brake line on a 1999 Mercury Sable, first, safely lift the vehicle and secure it on jack stands. Locate the damaged brake line, then use a line wrench to disconnect it from the brake components and remove any mounting clips. Cut and replace the line with a new pre-bent brake line, ensuring proper routing and securing it with clips. Finally, bleed the brake system to remove any air before testing the brakes.


Olds 3.5 v6 engine schematic?

Where can I find a engine schematic on line, for a 1999 Oldsmobile Intrigue 3.5 V6.


What is the brake line size on a 1999 Dodge Ram 1500?

3/16


1999 cadillac deville brakes fail while driving dashboard reads check brake fluid?

You have a hole in your brake line.


Does the master Cylinder on a 1999 s-10 have a vacuum line going to it?

No, the power brake booster has the vacuum line going to it.


How do you change the rear drivers side break line on a 1999 Chevy silverado above the gas tank.?

The brake line will have a retaining nut on each end of the line. Loosen the retaining nuts. Reverse the process to install the new brake line.


How do you fix a leak in the brake line at the rear drum of a 1999 Honda crv?

There is no safe way to repair a broken or leaking brake line. The line or tubing that is leaking must be replaced or a new piece of tube, spliced into the line with fittings, to replace the leaking area.


How do you remove the brake booster vacuum line of a 1999 Cougar 6-cylinder 2.5L?

Just pull it off