Different 240 volt watt water heaters use different amounts of watts! Look at your water heater. It should have a plate that lists the watts! On the other hand, the water heater only uses watts when it is heating water. If the family uses paper plates and takes brief showers by getting wet, turning off the shower, applying soap, and then rinsing, it will use a lot less electricity than if every member of the family runs out the tank of hot water taking a hot shower every day.
Watts is the amount of power the heater has and amps would be the draw- if it is a 120 volt heater than the amps would be 12.5 amps and it is instantaneous
To calculate the amperage for a 240-volt, 1500-watt electric baseboard heater, you can use the formula: Amps = Watts / Volts. For this heater, it would be 1500 watts / 240 volts, which equals 6.25 amps. Therefore, the heater uses approximately 6.25 amps.
To find the current in amps that a 750 watt, 120 volt heater draws, you can use the formula: Amps = Watts / Volts. So, 750 watts divided by 120 volts equals 6.25 amps. Therefore, the heater draws approximately 6.25 amps.
A typical 120 volt diesel engine block heater can pull around 1000-1500 watts, which would translate to approximately 8-12.5 amps. It's important to check the specifications of the specific block heater you are using to get an accurate measurement.
To calculate the breaker size for a 1500-watt 120-volt heater, use the formula: Breaker size = Power (Watts) / Volts. In this case, 1500 watts / 120 volts = 12.5 amps. Therefore, you would need a 15-amp breaker for a 1500-watt 120-volt heater to allow for a safety margin.
770 watts.
The heater should have a wattage rating (very few list amps). Calculate the amps using the wattage and voltage. Amps = Watts/Volts(480).
No, it is not safe to hook up a 220 volt water heater to a 110 volt outlet. The water heater will not function properly and can cause damage to the unit and potentially create a safety hazard. It is important to always match the voltage requirements of the appliance with the power source.
Amps, volts and watts are interrelated, but you need to do a little math. Amps * Volts = Watts
Watts = Amps X Volts Grab your calculator!
Volts * Amps = Watts 12 Volt * 2 amp = 24 Watts
no