0
What else can I help you with?
Where is the engine temp sensor on 1994 4cly ranger?
It should be on top in the intake manifold it should be near the thermostat housing. Good Luck !
Should you replace the slave cylinder when you replace the clutch in a 1994 ford ranger?
Not if it is working alright. however if you suspect its the worst for wear it would be a good idea,
What causes the turn signals on a 1994 Ford Ranger to stop working?
if only the turn signals are not working,you should replace the flasher can
Does the transmission of a 1994 ford ranger 2.3l have to be removed to replace the slave cylinder?
yes
Is it possible to replace the handle only on the parking brake of a 1994 Ranger?
yes it is very easy
How do you replace themastat HOUSING for 1994 Volvo 850?
To replace the thermostat housing on a 1994 Volvo 850, first ensure the engine is cool and disconnect the battery. Drain the coolant, then remove the hoses connected to the thermostat housing and unscrew the housing from the engine block. Replace the old housing with a new one, ensuring a proper seal with a new gasket, then reattach the hoses and refill the coolant. Finally, reconnect the battery and start the engine to check for leaks.
Where is the thermostat on a 1994 Chevy Beretta 3.1 z26 and how do you replace it?
The 1994 Chevrolet Beretta thermostat is located on the front of the engine. You can follow the top radiator hose directly to the thermostat housing. The thermostat will be in the thermostat housing.
How do you replace the head lamp bulb on a 1994 Ford Ranger?
(1) Open the hood; (2)unscrew the retainer from the back of the headlight; (3)pull the bulb socket out of the headlight assembly; (4)pull out the housing clips and remove the housing from the grill. NOTE:on later models there only 2 clips that are pulled up to release the headlight housing - one on each side. After pulling them up, simply move the headlamp housing forward from the vehicle. It may also be necessary to remove the headlight housing to change the bulb. - Haynes Repair Manual #36071; 1993-2005 Ford Ranger Pickups.
Where is the diagnostic port on a 1994 Ford Ranger?
On a 1994 Ford Ranger ( which is OBD I , EEC IV ) should have an EEC TEST connection in the engine compartment ( P.S. I'm not a mechanic / technician )
How do you replace the water pump on a 1994 Pontiac Sunbird?
you undo the tire housing and pull off the exaust manifold. replace the muffler fluid and then your done
How do you replace the headlight assembly located on a 1994 Ford Ranger?
detach the bulbs and remove the clips behind the headlight assembly
Where is the low oil level sensor unit located on a 1994 ford ranger?
It should be located in the oil pan. On my ranger its on the drivers side.
