0
What else can I help you with?
How do you tighten a fan belt on a Renault scenic?
The fan belt cannot be tightened. The scenic has a tention pulley that automatically adjusts the belt. If the belt is slack, it is either the wrong size or it is stretched and needs to be replaced immediately as serious damage can occur in the event that the belt should slip off.
Can you adjust tension of the fan belt on a BMW M54?
No, tensioner pulley is at a preset tension, no adjustment can be made. If there is slop in the belt, the spring loaded tensioner should be replaced.
How many fan belts are in a 1987 Jeep Grand Wagoneer Fan Power steering Alternator?
you should have three belts total. Going from the fan towards the distributer the first belt should be the power steering, then the actual fan belt, then the third belt is the alternator / a/c belt, i hope this is helpful for you! So for the answer to your question, there is one fan belt, the second belt in from the fan!
How do you adjust serpentine belt for mercury marquis?
You can't, the serpentine belt (or fan belt) on a grand marquis is equiped with a self tensioner, if your belt is making noise it either needs to be replaced or one of the pulleys on the cars may be loose and would need to be replaced.
i have a 04 trailblaze,i have a whining noise under the hood, replaced the tension pulley, surpanteen belt and had the air compresser replaced, what might be the issue. gary?
You did not mentioned the fan belt. That is the usual cause.
Do you have a picture of what the fan belt should look like?
I need diagram of the fan belt for a 1997 jeep wrangler sport
How should it cost to replace a fan belt on a 1988 Honda CRX?
theres no fan belt on front wheel drive motors. only a fan motor
How do you fix a noisy fan belt on a 1.4 si ford fiesta?
i owned a escort1.4 ,same problem,garage can tighten belt or it may need replaced.
How tight fan belt should be after replacing?
you would like about a 1/4" give in the belt
How tight should a fan belt be?
If it is a serpentine belt the automatic tensioner will adjust the belt for you. If it is an older "V" type belt--there should be 1/2" "play" at the middle of the belt, between the pulleys.
How do you change the fan belt on a 97 geo tracker?
Loosen the component slide it towards the engine to lossen the belt, remove belt. Install in reverse. If the fan is your problem it is held on with 4 small bolts, remove them and the fan. P/S you should be able to work the belt around the fan blades without removing the fan. On_mitch
Why do fan belts only squeak or slip bad in the cold weather?
A fan belt may squeak or slip badly in cold weather due to it being stiff from the weather. However, most likely you will need the belt replaced.
