I NEED PICTURES IF POSSIBLE TO TAKE DASH APART
Hi, I have a 2002 Cadillac Seville SLS. I would like to know how to reset the stability system? my message light came on.
there is no "reset" new pad and sensors is the fix if you have had this done they botched the job
The service suspension light on a 2000 Cadillac Seville will stay on if the sensor continues to detect a problem or it has become defective. Connecting an OBDII code reader to the car will help diagnose the problem.
there is a fusebox in the trunk (on lefthand wall).
ck grd at door switch and ck light module
To reset the change oil light on a 1996 Cadillac Seville, turn the ignition to the "ON" position without starting the engine. Press the gas pedal three times within five seconds. After doing this, the oil change light should reset and turn off. If it remains on, you may need to repeat the process or check for any underlying issues.
unhook to positive battery cable for about 5 mins, this will reset most codes unless there is a real problem
To change the reverse light bulb on a 1997 Cadillac Seville, first, open the trunk and remove the trunk liner or access panel to reach the tail light assembly. Next, twist the bulb socket counterclockwise to remove it, then pull the old bulb straight out. Insert the new bulb into the socket, replace the socket into the assembly, and secure it by twisting it clockwise. Finally, replace the trunk liner or access panel and test the new reverse light.
The senors need to be replaced, they are about $75.00 a piece and there are 4. Even if you replace the brakes; until replace the senors it will is flash change brake pads on dashboard
To reset the check engine light on a 1995 Cadillac Seville, you can disconnect the negative battery terminal for about 15 minutes, then reconnect it. This will clear the onboard computer's memory and turn off the light. Alternatively, you can use an OBD-I scanner to clear the codes if you have access to one. However, ensure any underlying issues are resolved to prevent the light from coming back on.
It means the engine computer has detected a malfunction and set a trouble code.