If you look strait at the headlight on the turn signal side you will see a small screw. remove it and the light should come out.
The headlight bulbs for the Chrysler LHS are inserted in the back of the light housings. There is a twist ring that holds them in, rotate the ring to remove and replace the bulb.
There
change a headlight on a 1997 plymoth voyager
There is no transmission light on a LHS.
In order to change the headlight on a 1994 Chrysler LHS, you must lift the hood and take off the shroud and the front grill. Then you can move the battery if you're changing the light on that side. There may be a few odds and ends that you may have take off to change the bulb but you should be able to reach and change the light bulb on your car.
You need three Polocks!
There are four oxygen sensors on the 1997 Chrysler LHS. 2 before the catalytic converter and 2 after.
1996-1997 Dodge Intrepid, Chrysler Concorde, Chrysler LHS, Eagle Vision.
Before replacing the headlight bulbs on a 1997 Acura CL prop the hood open. Locate the headlight housing and remove the old bulbs. Install the new lights.
To remove the headlight cover on a 1994 Chrysler LHS, start by opening the hood and locating the screws or clips securing the headlight assembly. Remove these screws using a screwdriver or socket wrench. Once the screws are out, gently pull the headlight assembly forward to detach it from the vehicle. Finally, you can carefully remove the headlight cover from the assembly.
A Chrysler LHS does not have an inertia or reset switch.
Passenger side is bank one on a LHS.