0
You need a 1 1/8 " spec. socket from the parts store (oil pressure sending unit socket, a regular deep well will damage the unit.) Most suppliers ship the unit with oil resistant Teflon tape on the threads. The unit is located on the middle of the block on the firewall side and is difficult but not impossible to reach. Once the electrical connection has been removed, it's pretty much like replacing a spark plug. Patience and care is required.
What else can I help you with?
How complicated is it to remove a transmission from a 99 Plymouth breeze?
Very. not a diy job
How do you get to the Fuel Pump on a 2000 Plymouth breeze?
You have to remove the fuel tank.You have to remove the fuel tank.
Where is the fuel pressure regulator on a 1997 Plymouth breeze?
The fuel pressure regulator on a 1997 Plymouth Breeze is typically located on the fuel rail, which is situated on the engine. It is a small cylindrical component that is connected to the fuel line. You may need to remove the engine cover or other components for better access. Always ensure to relieve the fuel system pressure before attempting any work on the fuel system.
How do you replace a washer pump in a Plymouth Breeze?
Remove the reservoir, remove the old pump and install the new one.
Where is crankshaft sensor located on 1996 Plymouth breeze?
On a 1996 Plymouth Breeze, the crankshaft sensor can be found above the oil filter. It should be accessible without having to remove any other parts.
How do you Remove oil pressure sending unit on 2.7 liter Chrysler engine?
Remove the oil pressure sending unit retaining ring. Remove the wiring harness from the sending unit. Poll the sending unit out of the engine.
How do you change the battery on a 1999 Plymouth breeze?
You have to remove the drive side tire and the wheel cover to get to the battery.
How do you replace the water pump on a 1997 Plymouth Breeze?
You must remove the timing belt to get to water pump.
How do you remove thumb twist screw to get to the battery on a Plymouth Breeze?
Push up on it turn ninety degrees and pull.
How do you remove a starter from a 1999 Plymouth Breeze?
Disconnect - battery terminal Raise and support vehicle Remove wiring harness from starter Remove mounting bolts Drop starter
Where is the oil pressure sensor switch located on a 1998 Plymouth Breeze?
The oil pressure sensor switch on a 1998 Plymouth Breeze is located on the engine block, typically near the oil filter. It can be found on the driver's side, towards the back of the engine, or near the oil pan. Accessing it may require some maneuvering due to tight spaces in the engine bay. Be sure to disconnect the battery before attempting to remove or replace the sensor for safety.
When do you change rotors on a 1999 Plymouth breeze?
Remove wheels Remove caliper mounting bolts Slide caliper off rotor rotor should slide off
