0
The oil pressure sensor switch on a 1998 Plymouth Breeze is located on the engine block, typically near the oil filter. It can be found on the driver's side, towards the back of the engine, or near the oil pan. Accessing it may require some maneuvering due to tight spaces in the engine bay. Be sure to disconnect the battery before attempting to remove or replace the sensor for safety.
What else can I help you with?
Where is the fuel rail pressure sensor located on a 98 Plymouth breeze 2.4L?
No such sensor.
Where is the oxygen sensor located on a 1997 Plymouth Breeze?
one before the cat and one after
Where is crankshaft sensor located on 1996 Plymouth breeze?
On a 1996 Plymouth Breeze, the crankshaft sensor can be found above the oil filter. It should be accessible without having to remove any other parts.
Where is the IAT sensor on a Plymouth breeze 96?
It is located on the back side of the intake manifold. Kind of hard to get to but reachable.
Where is the camshaft sensor located 1999 Plymouth breeze?
I have a 1998 plymouth breeze, and Mine is located if standing on the drivers side you will be facing it... it is right under the valve pan ...has three wires coming out of it. two small bolts holding it in place
Where is an overdrive sensor and how to change it on a 1996 plymouth breeze?
There isn't an overdrive sensor. There are pressure switches, a temp sensor, solenoids, and speed sensors.There isn't an overdrive sensor. There are pressure switches, a temp sensor, solenoids, and speed sensors.
Where is the Location of the throttle position sensor for a 1997 Plymouth breeze?
the TPS or throttle position sensor is located on the throtttle body which must be removed before replacing tps
How do you stop a map sensor from going bad on a 99 Plymouth breeze?
You can not prevent a sensor from failing.
1997 Plymouth breeze randomly stalls and starts?
Start by checking the 1997 Plymouth Breeze for proper fuel pressure. Also check for any loose connections at the crank position sensor or the coil packs. Any of these could cause the stalling problem.
Where is the power steering sensor located at in a Plymouth neon?
It screws into the pressure line at the rear of the engine.
Where is the oil pressure sender on a Plymouth Breeze?
Mine is on the back of the engine block.. right above the drive axle , there is one there called crankshaft sensor and then right above it is the oil pressure sensor mine has one wire coming out of it...
Why does a 1996 Plymouth breeze start and run until it gets warm then stalls and wont start again until it cools off?
A 1996 Plymouth Breeze that starts and runs until it warms up, but then stalls might have a problem with a temperature sensor. The sensor is telling the computer that the temperature is too high for the engine to operate safely. Check the Electronic Temperature Sensor or the Manifold Pressure Sensor (MAP).
