Is the key broke off? if it is not broken off make sure gear selector is in park.If it is broke off I have been able to pick keys out using a needle or a dental pick.
Answerturn your steering wheel hard to either side. this should free up the key to be able to turn it.
when you park your car make sure the clutch is disangage .then you can remove the key same problem is with my Volvo s40
how to remove key stuck in ignition switch in Chevy colbalt
remove battery cable
To remove a key that is stuck in the ignition on a Peugeot 406 HDI, make sure that the car is in park. Then try to remove the key. If this does not work, spray the ignition mechanism with WD-40 after pulling out the key as far as possible. Then work the key in and out until it comes out.
Use the opportunity to replace the ignition. Key needs to be in On position for removal.
There should be a lock on the ignition a push button that you push and turn to remove the key
See You-Tube Video : http://youtu.be/lBNUuO4ldfI How to Remove a broken key from an Ignition. Using the Broken Key Extractor Kit from: www.WedgeCo.com
Well, it sounds like the chip that is in your key may have broke or got stuck on a part of the ignition. I had that problem. This happened not long after I had had to have the ignition replaced?!?
is it a ford? push the key in further and then turn it
Try to put your car on the parking breakes.
To remove a stuck key from the ignition of a Chevy Captiva, first ensure the vehicle is in the "Park" position, as the key can get stuck if it's in gear. If the key still won’t turn, try gently wiggling the steering wheel back and forth while turning the key. If the key remains stuck, check the battery; a dead battery can prevent the key from being released. If these steps don’t work, it may be necessary to consult a mechanic for further assistance.
To remove the ignition lock cover with a broken key stuck in the ignition, first ensure the vehicle is off and disconnect the battery for safety. Use a small screwdriver or a pick to try and extract the broken key piece from the ignition. If that doesn't work, you may need to remove the steering column cover by unscrewing it, which typically involves removing screws located underneath the steering wheel. Once the cover is off, you can access the ignition switch to replace it or remove the lock cylinder if necessary.
You can't, you have to replace the ignition switch