there is a 10 mm bolt right underneath the coolant reservoir an a clip securing it down in the back remove both of those and it will come out
On a 2001 Ford Focus : The thread on cap on your engine coolant reservoir is the pressure cap / radiator cap
Add the coolant into the coolant reservoir. Be sure the engine is cool when you remove the cap off the reservoir.
The thread on cap on your engine coolant reservoir is the pressure cap / radiator cap
Where is the coolant temperature sensor on a 2001 ford focus?" Where is the coolant temperature sensor on a 2001 ford focus Where is the coolant temperature sensor on a 2002 ford focus
To replace the coolant reservoir on a 2001 Oldsmobile Intrigue, first ensure the engine is cool and disconnect the negative battery cable. Remove any mounting bolts or clips securing the reservoir, then carefully detach the hoses. Install the new reservoir by attaching the hoses and securing it with the bolts or clips, then refill the coolant and check for leaks before reconnecting the battery.
The engine coolant reservoir is in the engine compartment , on the drivers side , near the firewall
Coolant is added to the plastic reservoir under the hood.
Top off the coolant reservoir.
Clean the reservoir and flush the cooling system.
In a 2001 Mercury Sable, the coolant low sensor is typically located in the coolant reservoir tank. It is a small plastic component that detects the coolant level and sends a signal to the vehicle's dashboard if the level is low. To access it, you may need to remove the reservoir tank from its mounting position. Always consult the vehicle's service manual for specific instructions and safety precautions.
Fill the reservoir with G12 VW coolant only and it will go into the engine.
In a 2001 Chrysler Town & Country LX, you pour coolant into the coolant reservoir, which is typically located near the front of the engine compartment. Look for a translucent plastic tank with a cap labeled for coolant or antifreeze. Ensure the engine is cool before opening the cap, and fill the reservoir to the appropriate level marked on the side. If you need to add coolant directly to the radiator, make sure the engine is cold and carefully remove the radiator cap.