answersLogoWhite

0

first you have to remove the part where the mirror is adjusted on the inside, it snaps off with 3 clips. You can stick a screwdriver under there wrapped in a little Duct Tape to keep it from scratching the door. After you do that, you have to remove the clips from the door handle in the middle and the door opening handle near the top, and remove the screws/bolts there. Make sure there are no bolts under that mirror cover that you just removed, then just start going around the door, its got the same clips as the mirror cover does, it will require some effort, and 1 or 2 can bend...chalk it up to chevy.....

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

How do you remove the radiator in a 2006 Chevy Cobalt?

with the correct tools


Where is the radio fuse in a 2006 Chevy cobalt?

In a 2006 Chevy Cobalt, the radio fuse is located in the fuse panel inside the vehicle. This panel is typically found under the dashboard on the driver's side. To identify the specific fuse for the radio, refer to the diagram on the fuse panel cover or consult the owner's manual for the exact fuse number and location.


Where is shift solenoid locate on 2006 Chevy Cobalt ss?

inside the transmission....you have to remove the side panel to get to it. It is a job for a dealer...cost will be about $800. The A-frame needs dropped along with the rack, and the tranny tilted back.


How do you remove inner door panel on 2006 Chevrolet Malibu?

what steps are required to remove the inside door panel on a 1997 Chevy Malibu.


How do you change the timing belt on a 2006 Chevy Cobalt?

how do you change the timing belt on a 2006 Chevy Cobalt You need to purchase a Haynes Manual at a parts or bookstore.


How do you remove the radio trim from a 2006 Chevy Cobalt?

all the trim panels are held in by clips and they just simply snap off


How do you install tail light bulb Chevy Cobalt 2006?

Remove tail light housing. Remove lamp. Replace lamp. Replace tail light housing.


Remove ignition lock cylinder 2006 chev cobalt?

The ignition lock cylinder on a 2006 Chevy Cobalt is removed by popping off the steering column cover and inserting a screwdriver into the release hole. The cylinder can then be pulled from its housing and replaced.


How do you change a rear hub on a Chevrolet Cobalt?

how to change rear hub on 2006 chevy cobalt 2.2l


What is the torque specification for spark plugs on a 2006 Chevy hhr?

specification on gapping spark plugs for 2006 chevy cobalt


How charge the battery in a 2006 Chevy Cobalt?

Open your trunk, remove the carpet as if you are getting to the spare tire and the batterie is located there, remove it with a socket wrench and take it to your local autozone for charging.


2006 Chevy Cobalt fuel capacity?

Roughly 13 gallons