0
My Montana is a 2005; but I believe the set process is the same: 1. Some vans may have a hard plastic "protector" located at the corner. If that is the case, remove it by pushing it up by its clips. 2. You have to remove the round bar. There are two bolts in front and one in the back by hood hinge. The round bar slides out of the relay box. 3. Remove the wire connecting to the relay box to the battery by removing the holding nut. 4. Lay the relay box over - towards the motor. 5. Remove the hold-down bolt located on the backside of the battery at the bottom. 6. Remove the batter posts bolts. 7. Remove old battery. 8. Put new one in and reverse the above steps. Good Job! .
What else can I help you with?
2001 Pontiac Montana overheating?
2001 Pontiac Montana?
How do you replace the serpentine belt pulley on a 1997 Pontiac Montana?
it is a 2001 Pontiac Montana that has broken three bealts so far I need to know what pully I will need to replace?
How do you replace a heatercore in a 2001 Pontiac Montana?
To replace the heater core in a 2001 Pontiac Montana, start by disconnecting the battery and draining the coolant from the radiator. Remove the dashboard and center console to access the heater core, then disconnect the hoses and any electrical connections. Carefully remove the old heater core and install the new one, reassembling the components in reverse order. Finally, refill the coolant, check for leaks, and reconnect the battery.
How do you change the thermostat on a 2001 Pontiac Montana Minivan?
To change the thermostat on a 2001 Pontiac Montana Minivan, first, ensure the engine is cool and disconnect the battery. Then, locate the thermostat housing, which is typically near the engine's upper radiator hose. Remove the hose and the housing bolts, take out the old thermostat, and replace it with a new one, ensuring the gasket is properly seated. Reassemble everything, reconnect the battery, and refill the coolant as necessary.
How do you remove the radiator of Pontiac Montana model 2001?
To remove the radiator from a 2001 Pontiac Montana, begin by disconnecting the negative battery cable and draining the coolant from the radiator. Next, remove the radiator hoses and any electrical connections. Unscrew the mounting bolts that secure the radiator and carefully lift it out of the engine bay. Be sure to replace any gaskets or seals during reinstallation.
How much refrigerant is needed to recharge AC on a 2001 Pontiac Montana?
How much refrigerant is needed recharge ac on a 2001 Pontiac montana
Where is the vacuum modulator on a 2001 Pontiac Montana?
2001 Montana has an electronic transaxle. There is no vacuum modulator. The 2001 Montana has an electronically controlled transaxle. There is no vacuum modulator.
2001 Pontiac Montana Radiator?
yes it has one
Where is radio fuse located in 2001 Pontiac Montana?
No
How do you replace a abs module on a Pontiac gran am gt?
Pick up the Haynes repair manual, it goes through the process step by step. I found it through Amazon.com. I am about to replace the one on my 2001 Pontiac Montana. Good Luck
How do you replace 2001 water pump on Montana?
To replace the water pump on a 2001 Pontiac Montana, first disconnect the battery and drain the coolant. Remove the serpentine belt and any components blocking access to the water pump, such as the alternator or engine covers. Unbolt the water pump, clean the mounting surface, and install the new pump with a new gasket. Reassemble everything in reverse order, refill the coolant, and check for leaks.
How do you fix gas gauge on a 2001 Pontiac Montana?
sounds like the fuel sensor inthe fuel tank which means removing tank to replace
