0
To replace the heater core in a 2001 Pontiac Montana, start by disconnecting the battery and draining the coolant from the radiator. Remove the dashboard and center console to access the heater core, then disconnect the hoses and any electrical connections. Carefully remove the old heater core and install the new one, reassembling the components in reverse order. Finally, refill the coolant, check for leaks, and reconnect the battery.
What else can I help you with?
2001 Pontiac Montana overheating?
2001 Pontiac Montana?
How do you replace the serpentine belt pulley on a 1997 Pontiac Montana?
it is a 2001 Pontiac Montana that has broken three bealts so far I need to know what pully I will need to replace?
How much refrigerant is needed to recharge AC on a 2001 Pontiac Montana?
How much refrigerant is needed recharge ac on a 2001 Pontiac montana
2001 Pontiac Montana Radiator?
yes it has one
Where is radio fuse located in 2001 Pontiac Montana?
No
Where is the vacuum modulator on a 2001 Pontiac Montana?
2001 Montana has an electronic transaxle. There is no vacuum modulator. The 2001 Montana has an electronically controlled transaxle. There is no vacuum modulator.
How do you replace a abs module on a Pontiac gran am gt?
Pick up the Haynes repair manual, it goes through the process step by step. I found it through Amazon.com. I am about to replace the one on my 2001 Pontiac Montana. Good Luck
Where is the ECU on the 2001 Pontiac Montana?
under the antifreeze compartment
How do you fix gas gauge on a 2001 Pontiac Montana?
sounds like the fuel sensor inthe fuel tank which means removing tank to replace
Where is the block heater cable on my 2001 Pontiac Montana?
The 2001 Pontiac Montana block heater cable can be found in the front of the vehicle. You can access the block heater cable through the front grill.
How many fuel pump fuses on Pontiac Montana 2001?
There is only one fuel pump fuse on a 2001 Pontiac Montana. It can be found in the engine compartment near the firewall at the rear of the compartment.
How do you replace a starter on a 2001 Pontiac Montana?
Remove the wires from the starter. Remove the retaining bolts. The starter will easily come out. Reverse the process to install the new starter.
