hi Philip north London n4 here
The BSI unit is basically a computer which
handles a multitude of functions such as
odometer value, central locking, lights and
immobiliser. Some later Bsi units are liable
to corrupt their own software program if
not "woken up" in a specific way after
programming keys or battery disconnection.
The details of this are explored
thoroughly in a Peugeot TSB but I will
summarise for you briefly.
Procedure for Initialising the BSI after key learning
1. Disconnect the diagnostic tool.If being used.
2. Put the driver's window down, lift the bonnet and ensure all
equipment is switched off.
3. Ensure all doors are closed and remove key from the
ignition.
4. Wait for 3 minutes, disconnect the vehicle battery and wait
15 seconds.
5. Reconnect the vehicle battery, wait a further 10 seconds (do
not open doors.)
6. Switch on the side lights through the driver's window.
7. Switch on the ignition and check system's functionality.
8. Hold lock button on key down for 10 seconds.
9.remove key open & close door test c entral locking system
10. Start the engine and complete the system's check.
Failure to follow this procedure could result in incorrect operation of many
BSI related items.
It did take three attempts following this procedure before it worked.
How do you turn on automatatic door lock on a citroen picasso
Keep the the lock botton pressed for several seconds (2sec). A message will appear on the screen to confirm the new settings
To reprogram a Honda ignition key you need to use a Honda-approved dealer. Only a dealer can reprogram or order a new ignition key for a Honda vehicle.
leave the key in the ignition over night key should reprogram
Doors are not locking and the dashboard says boot open whenever the ignition key is turned on
on my 2002 picasso there is a key slot on the end of the dash located on the passenger side, open the door and you will see it, use your key to turn it off
Turn on the ignition with the key. Whilst on press one of the buttons on the key.
i have had a new battery in my key fob, but it wont turn the engine on, do i have to get it tuned in to the electrics.?
Turn the ignition key midway (electric position) the press on the button at the end of the wiper stalk until you hear 2 beep and message display on the information display "Automatic light inactive"
The key is almost never the problem, there is a halo ring around ignition and module in dash that are usually the problem- you need an auto locksmith to test them
This can only be done by Ford dealer. It is expensive!
I got a copy of my Picasso key from Timpson.They have 900 outlets around the UK.A lot of the Timson stores cut and supply car keys.They tell you how to tune in the ''chip'' in the key to your car.It cost me £40.
To reprogram the alarm remote for a Porsche boxster, one must put the key into the ignition and turn to position 1, first click. After, you must then turn the ignition off and leave the key in for approximately 15 seconds. The last step is to start the car; this will successfully reprogram the remote.
You have an immobilizer problem. Try another key.