answersLogoWhite

0

twist it. righty tighty, lefty loosey

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

How do you replace the gas tank strap bolts on a 1990 Dodge Dynasty?

you cant, you will have to drill new holes, and place the straps there. for safety reason's you can not take the old bolts out


What size bolts are in the tank strap for 2001 Chevy blazer?

It will take a 15mm socket to r&r them.


Where is the fuel pump located on a 1994 Chevy C-10?

It's inside your gas tank. The gas tank is on the left side of the vehicle. There is a strap that goes around it and bolts to the frame and a strap that goes around it and bolts to a crossmember. If you get under there and look you can see the hoses coming from the top of the tank. That's the fuel pump.


How do you remove the straps on the gas tank on a 1994 ford van?

Remove the bolts on one end of the strap and the strap should pivot down from the hinged end. Use ample lubricant on both ends of the strap.


How do you Remove Audi 80 fuel tank?

Haven't seen an 80 one, but I've had a look at my 96 A4, very similar. To get it out, undo the bolts at the end of each strap. (3 straps 4 bolts?) What I want to know, is how to get it back in again!


How do you replace the fuel tank strap on your 93 ranger?

I just replaced the rear strap on my 94 ranger, 3.0 engine, extended cab 125" wheel base. Basically I removed the heat shield on the passenger side (4 bolts) - if there was a shield under the tank, it was missing on my truck. After the shield was out of the way, I supported the tank with a jack using a piece of wood to protect the tank. I then removed the bolts (2 - one on the heat shield side and one at the rear of the tank) for the rear strap and removed the bolt on the front strap (one - heat shield side). I was then able to push the tank over enough to remove the part of the rear strap hooked into the frame. I then hooked the new strap into the frame and put every thing back together. I used a wood wedge to hold the tank out of the way while I worked and although it was very tight, it wasn't too difficult. I don't believe the front strap can be replaced this way because it's much tighter between the tank and the frame. Hope this helps - Good luck.


How do you drop a fuel tank on 1989 Chrysler new yorker?

On the tank you will see 2 straps around it,towards the back side (trunk) at the end of strap there will be a bolt in each strap, put a floor jack with a piece of wood about the width of the tank under it , remove the bolts, next using a screw driver remove the hose clamp holding your filler tube to the tank, pull hose off and let your jack down slowly.


How do you gauge a frac tank?

How do i strap a frak tank


How would you drop a fuel tank that is full in a 1988 Olds Cutlass Supreme to change the fuel pump?

In case you decide to go ahead I've done it before, in the rain and in a dirt parking lot, sometimes you don't get to choose. raised the back up as high as I could and blocked it with jack stands, then I positioned the floor jack under the tank. I loosened all the tank strap bolts and then took the weight off the tank with the jack, then I removed the two rear tank strap bolts and let the tank drop in the back slowly so I could see the connections. I then removed the electrical connections and hoses from the top and lowered the tank to the ground where I could replace the fuel pump. When I got ready to put it back in I slid the tank onto the strap ends that were hanging down from the front and pushed that side up into position while supporting the back, from there I set all the connections again, after that it was just wrangling the tank into position so I could bolt the straps again.Another opinion.You don't! Remove as much gasoline from the tank as possible before removal.Oh... but I did...there is an anti siphon screen at the tank...makes it hard to drain it... and it went fine... thanx n e ways


How do i remove fuel tank on 1997 suburban?

There are two straps on the fuel tank if you follow them up you will see two bolts that hold the strap to the frame if the fuel tank is not empty put a jack under it to hold it up so it wont fall.


How do you replace fuel tank 1970 Monte Carlo?

Unplug sending unit wire. There are two straps holding up the tank.....one bolt in each strap. Remove the bolts. Remove any clamps and hoses running to the tank. Lower it out.


Where can you find a fuel tank assembly diagram for a 1996 Plymouth Voyager?

The fuel tank is just the tank itself. With the fuel pump built into the tank. Remove the tank by draining as much gas as you can out first via siphon. Support tank and remove the retaining strap bolts. Carefully lower and remove the wiring and fuel lines.