you cant, you will have to drill new holes, and place the straps there. for safety reason's you can not take the old bolts out
you hump it you cut it
How do u replace a hood release strap on a Mercedes c230
To replace the sliding sternum strap on your backpack, first locate the attachment points on both sides of the strap. Then, carefully remove the old strap by detaching it from these points. Next, thread the new strap through the attachment points and adjust it to your desired length. Finally, secure the strap in place by fastening it securely.
Yes you need to at least replace the one that is broken and check out the other one and see that it might need to be replaced!
To replace the sternum strap on your backpack, first locate the attachment points on the shoulder straps. Then, thread the strap through the attachment points and adjust it to your desired height and tightness. Make sure the strap is securely fastened before using your backpack.
My buddy did the same thing. It was a ground strap from firewall/frame to the engine had broke when he lowered the engine to remove the top bolts. I have seen the ground strap go from frame to one of the bellhousing bolts. Check the wires at the coil too-they may of come off/loose when you lowered the engine or reached behind it.
Well no easy way to say this.... Fuel filter is in the tank and the fuel pump and filter is one unit!! Messed up I know but that's where it is. Drop the tank by removing the strap bolts, pump goes in through the top of the tank. Good luck! Starting price for a pump is around $200
Remove the bolts on one end of the strap and the strap should pivot down from the hinged end. Use ample lubricant on both ends of the strap.
Disconnect the filler pipe connection and loosen the two strap bolts that hold it up. Lower it on a jack enough to undo the wiring and fuel line connections, that's all there is to it.
twist it. righty tighty, lefty loosey
You should have You're normal ground from you're battery to the engine block a small secondary ground from you're battery to the radiator support. That one is about a 10 or 8 gage wire. You should also have a flat ground strap running from the back of the engine to the frame. The strap is sometimes through one of the bell housings bolts It is more out of the and less likely to get ripped off if it is fasten to the exhaust manifold bolts. Good luck!
22 gallons. You can easily replace it with a 35 gallon gas tank but a third support strap is required with the larger tank. If you order a larger tank from a wrecking yard, be sure to tell them that you want the third strap too.