0
What else can I help you with?
Is a John Deere 318 2000RPM rear PTO the same shaft size and spline number as a 6 spline 540RPM standard PTO?
No, it is not. A 2000RPM rear PTO shaft has a 1 inch by 15 spline yoke
What rear end came stock on 1996 Chevrolet z71?
GM8.5 inch 30 spline 10 bolt 3.73 gear ratio , 41x11
What is the ring size and number of splines for a 1982 El Camino 10 bolt?
Ring gear size is 8.5 inch , 28 spline axles .
Weight of 50 ft section of 3 inch fire hose?
Weight of 50ft section of 3 inch hose with water in it?
Are 16 or 24 inch on center studs better?
16" on center stud walls are stronger than 24 inch on center walls.
How long is an inch in center meters?
1 inch = 2.54 centimetres
What does the three inch and four inch mean when talking about lavatory faucets?
I have never heard of 3 inch, but I would assume it refers to the spacing of the hot and cold lines. Standard in the U.S. is 4 inch center to center.
How do you change 10 inch toilet rough in to 12 inch?
You cut the drain line and add a 2" section.
Are ford f350 rims interchangeable 16 to 17?
Ford F-350 rims from 16-inch to 17-inch sizes are generally not interchangeable due to differences in diameter and possibly width. The bolt pattern and offset may be compatible, but the overall size difference means a 16-inch tire won't fit on a 17-inch rim and vice versa. Always check specific vehicle specifications and consult with a professional before making any changes.
What are PPI and DPI?
PPI stand for Pixels Per Inch and refers to resolution (number of pixels in a single inch) on a screen. DPI stands for Dots Per Inch and refers to resolution (number of ink droplets in a single inch) on a printed page. the two terms are often used interchangeable .
How do you put a dana80 rear from a 2004 dodge into a 2001 dodge?
A 2004 did not have a Dana 80. That is an American Axle 11.5 inch. The parts are not interchangeable.
What is about an inch in length?
Each section of your thumb, on each side of the joint, is.
