If there is a bypass pulley you'd have to go to a dealer to get it. You can remove ac compressor and get a short belt bypass it that way. Same belt routing minus the ac. I just did my 2004 Ford Taurus used a 8206k belt. was a lil hard to get on or maybe I'm a wimp.
AnswerGo to www.dormanproducts.com and look up an A/C bypass pulley for your vehicle. Then go to www.rockauto.com to buy it.To remove the AC compressor on a 2001 Ford Taurus for installing a bypass pulley, first, disconnect the negative battery terminal. Then, drain the AC system by removing the refrigerant, which should only be done by a certified technician. Next, remove the drive belt and disconnect the electrical connector from the compressor. Finally, unbolt the compressor from its mounting bracket and carefully remove it to install the bypass pulley in its place.
I am unsure what you mean by bypass. The Air Conditioning system will not work with out the compressor. The compressor can be disabled by unplugging the electric clutch. Most of these little Fords could have a different length belt fitted so the compressor pulley didn't turn at all.
It takes an 82 inch five grove belt.
No you can not bypass the ac pulley but you can by a bypass pulley at the part store for about 40$. I just got one for my 2006 ford taurus the ac pump locked up and burned my belt it can take a while to put on but its worth it if you dont mind not having your ac working.
can you bypass a 2001 oldsmobile aurora ac compressor?
With a compressor bypass kit from a part store.
To bypass the AC compressor on a 1992 Ford Taurus with a 3.8L engine, you'll typically need a serpentine belt that is approximately 73.5 inches long. It's advisable to confirm this size with your vehicle’s specific setup, as variations may occur based on manufacturing changes or previous modifications. Always check your vehicle's manual or consult with a parts store to ensure you have the correct belt length for your bypass configuration.
If it's a Taurus GL, you would also have to bypass the Power steering pump. Recently my A/C compressor ceased up on me. I tried bypassing the compressor but the belt ran against a hose that was near the PS pump so I had to shorten it to include only the water pump and alternator. I had to also drop the alternator ( reomoved the anchor bolt) to make the shorter belt fit. I am still driving the car but no A/C or power steering. The best thing to do would be to go to your nearest auto wreckers and get a used compressor. hope this helped.
To bypass the AC compressor on a Ford Taurus, you typically need a belt that is one or two sizes shorter than the standard accessory belt. For most models, a belt size of around 6PK2100 (or similar, depending on the engine) is often used for the bypass. However, it's crucial to check the specific engine and year of your Taurus, as sizes may vary. Always consult the vehicle's manual or a parts specialist for the correct size.
You remove the ac compressor and install a pulley bypass kit from a part store.You remove the ac compressor and install a pulley bypass kit from a part store.
Most likely the new pulley is not in line with the rest.
yes you can, just go buy an ac bypass pulley, pull your compressor, and put pulley in its place