answersLogoWhite

0

What else can I help you with?

Related Questions

Where is the ac high pressure switch on a 1996 Plymouth breeze?

It is located on the discharge side of the compressor. On a 2.4L engine you will need to jack the vehicle up to get to it.


1999 Plymouth breeze what antifreeze does it need?

green


What type of brakes do you need for the rear of a 1990 Plymouth breeze?

There wasn't a Breeze in 1990.There wasn't a Breeze in 1990.


Your AC compressor on your 97 Plymouth Breeze is smoking you've been told that you need to purchase a new one for the car to work properly but is there any way to just simply disconnet the ac?

yes


97 Plymouth breeze that needs a motor how much can you sell it for?

it might just need to be reset Ihave the same problem with my breeze


Towing a Plymouth breeze without damaging transmission?

The front tires need to be off the ground.


How do you bypass the compressor on a 1996 dodge stratus 2.4 L?

bypassing the a/c compressor is easy, all you need to do is buy the buypasser kit from an autoparts store, or a website like www.summitracing.com they have the pulley on there.


How do you level and aim the headlights on a 97 Plymouth Breeze?

You need special equipment to do this correctly. Take it to a dealer for this.


AC compressor is broken on 1997 sunfire do you need to repair it if you don't want air?

Nothing if the compressor bearings are good. Just unplug the wires at the compressor or pull the fuse. If the compressor is locked up or the bearings are shot, then you need to purchase a belt for a 1997 Pontiac Sunfire that came from the factory without A/C. Install the belt, bypassing the compressor, and just leave the compressor alone.


What do you need to do your 1999 Plymouth breeze only blows cold air?

check the coolant in the radiator it may be low.


What would cause a 1998 Plymouth Breeze to stall when you turn the AC on?

It could be the AC compressor. With the engine and key off, try turning the compressor by hand. The belt should be connected to a pulley that drives the clutch. With the engine off the cluth is disengaged so you should be able to turn the inner part of the compressor pulley even though the outer part is connected to the belt. If it won't turn at all, it's probably siezed and you need a new compressor.


How much transmission fluid do I need after changing the transmission filter in a 99 Plymouth Breeze?

It will require around five quarts.