0
The 1998 General Motors/Oldsmobile Cutlass came equipped with the 3100 V6. This vehicle has multiple O2 sensors located up and downstream of the catalytic converter. Removal and replacement of the O2 sensors requires first disconnected their wiring harnesses. Then they can be removed from the exhaust piping by a wrench. If the mileage is sufficiently high enough it is advisable to replace them altogether.
What else can I help you with?
What are all the possible compatible engines that can be used to replace an engine from a 1997 Chevrolet Cavalier?
*96-98 Olds Achivea *96-01 Pontiac Grand Am *99-01 Olds Alero *96-01 Pontiac Sunfire *96-01 Chevy Malibu *96-? Buick Skylark *96-98 Olds Cutlass
How do you replace crankshaft position sensor on a 1988 olds 98?
To replace the crank sensor you have to remove the harmonic balance taking special attention not to damage the pulley or the cam shaft. Remove the two 10mm retaining screws
How do you replace a heater core on a 93 olds 98?
how do you replace a heater core in a 91 Oldsmobile 98
87 Oldsmobile 98 not a cutlass?
No. It's a 98. Not a Cutlass.
How do you replace the washer pump on a 86 olds 98?
Get a hammer, and break it
Where is the outside temperature sensor located on a 1994 olds 98?
Between the radiator and the grille!
How do you replace a crank sensor on a 98 cavalier?
Bob
How do you replace the throttle position sensor in a 98 Olds intrigue?
The 1998 Oldsmobile Intrigue throttle position sensor is held in place with two retaining screws. Remove the retaining screws and the wiring harness. Reverse the process to install the new throttle position sensor.
How to replace fuel pump on 98 olds?
Remove fuel tank for access
Where is the radio fuse located on a 98 olds cutlass supreme?
On a 96, there is a fuse panel on the right side of the dash, against the right door.
How do you replace cam sensor on 98 volkswagen golf?
Chek
Labor cost to replace oxygen sensor on olds silhouette?
On July 3, 2008 I was quoted $120 to change one oxygen sensor on a 98 Silhouette. Since the part is probably around $80, I would guess $40 is for labor. This is in Texas. Gary
