yes
yes!! by the starter and put it in!
different part numbers. I don't think they interchange.
It would help to know the sensor that needs resetting.
In a 2000 Ford Explorer, the starter relay is located in the engine compartment, specifically in the power distribution box. This box is typically found near the battery on the driver's side. You can identify the starter relay by referring to the diagram on the cover of the power distribution box, which indicates the specific location of each relay and fuse.
Follow the + battery cable should connect to the starter solenoid (relay) either at the top of starter or at the inner fender perhaps under battery
In a 2000 Ford Explorer, the starter fuses are located in the power distribution box, which is usually found under the hood on the driver's side near the battery. You can identify the specific fuse for the starter by checking the diagram on the cover of the power distribution box. Additionally, there may be a relay for the starter located in the same box. If you're troubleshooting, ensure to check both the fuses and the relay for any issues.
Not a problem. The starter gear will take care of that. It is autoaligning when you turn the ignition switch.
Depending on where a person lives and where they have the repair done, the labor for replacing the starter on a 2000 Saturn SL2 will cost between $186 and $238. The cost for the parts will be $149 to $261 plus tax.
I have recently replace my starte for 2000 nissamn maxima gle and it cots around 500 usd with parts and labor.
It "CAN", but why would you want to? The contacts in the solenoid wear at about the same rate as everything else inside the starter. If the solenoid is bad you'll be better off just replacing the whole thing because the brushes or bushings will be going next then you'll get to remove/replace the starter again.
To overhaul the starter on a 2000 Polo Playa, first disconnect the battery to ensure safety. Remove the starter by unbolting it from the engine and disconnecting the wiring. Disassemble the starter by taking off the end plate, inspecting the brushes and armature for wear, and replacing any damaged components. Reassemble the starter, ensuring all connections are secure, and then reinstall it in the car before reconnecting the battery.
i have 2000 bmw 323i 4 dr sedan and need to change motor starter , can tell me where it is? and step by step with pictures if it possible how to remove and reinstalled it . thank you max