Anyway, the part# from napaonline.com is BK 6653601 for the drivers side (BK 6653602 for the passenger side).
Remove the door panel, time consuming but not too hard. Loosen the three 10mm bolts holding the motor in, remove the power connector.
Lower the window so that the two bolts holding it to the regulator are exposed, remove them. Push the window to the top, propping it at this position (a screwdriver through the access hole at the top left will prop on top of the exterior door handle keeping the window in place.
Remove the three 10mm bolts holding the regulator in place. 'Corkscrew' the regulator and motor out of the BIG hole at the back of the door.
Installation is the reverse of assembly.
EASY!
need instructions on replacing window regulator
need to know how cables connect on window regulator
usually by replacing window regulator.
window regulator. about 400 bucks
The bracket snaps on the window over the plastic pin in the window. You need to pull the bracket away from the window to get it down and over the plastic pin. If you will be replacing the window regulator you can just cut the bracket where it snaps over the pin.
either smash it or take it to a body shop.
You do not reattach any mechanism. You will have to replace the window regulator.jd
If it is electric windows it is the motor which needs replacing or it could be the regulator
The process to replacing the window regulator involves removing the door panel,connections to the window switch and also the door handle bezels. I've included a video that will show you exactly what tools you need and how to get at the window regulator so that it can be replaced.
When replacing the regulator on a 2006 Ford Fusion, you need to follow the instruction on the manual so as to be able to replace the actuator on a 2006 Ford Focus with power window.
The antenna is integrated into the rear window. If you look at the rear window, you will see the grid for the rear window defrosters as well as a grid that is the antenna
To remove the window regulator from a Vauxhall Vectra, start by disconnecting the battery and removing the door panel to access the regulator. Carefully detach any electrical connectors and screws holding the regulator in place. Once unfastened, slide the regulator out from the window channel and pull it out of the door cavity. Finally, ensure to reassemble everything in reverse order after replacing or repairing the regulator.